We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black push-fit tee fitting with NPT thread, pack of 10

Legris

Legris 3108 10 18 Male Branch Tee 3/8 NPT Push-Fit Trap

SKU CH-J1T9-73TR8 MPN 3108

Connects two 10 mm tubes to a 3/8 NPT thread with push-fit ends and pre-applied sealant

  • TypeDrain Components
  • MaterialHAWA
  • ColorBlack
  • Push-to-connect design enables tool-free tube installation
  • Male NPT thread provides secure connection to female ports
  • Fiberglass-reinforced nylon body resists corrosion and chemical exposure
  • Pre-applied thread sealant eliminates separate sealing step
  • Supports 10 mm tubing on both push-fit branches

Male Branch Tee for 10 mm Tubes

This push-fit tee connects two 10 mm outer-diameter tubes to a 3/8 NPT male thread. The body is moulded from fiberglass-reinforced nylon and includes pre-applied thread sealant on the NPT end. It is supplied new in a pack of ten pieces.

Suited for Air, Cutting Fluids and Inert Gases

The fitting handles compressed air, cutting fluids and inert gases in industrial or automotive plumbing. It is not intended for potable water, fuel, hydraulic oil or high-pressure steam systems where different materials or certifications are required.

3/8 NPT Male Thread with 10 mm Push-Fit Ends

The single specification that decides fitment is the combination of a 3/8 inch NPT male thread on the branch and 10 mm push-to-connect ports on the two run ends. Verify both thread size and tube diameter before ordering.

Highlights

  • Push-to-connect design enables tool-free tube installation
  • Male NPT thread provides secure connection to female ports
  • Fiberglass-reinforced nylon body resists corrosion and chemical exposure
  • Pre-applied thread sealant eliminates separate sealing step
  • Supports 10 mm tubing on both push-fit branches

Specifications

TypeDrain Components
MaterialHAWA
ColorBlack
BrandLegris
Model3108 10 18

Questions about this item

What does the 3/8 NPT male thread on the branch side connect to?

The 3/8 NPT male thread connects to a female NPT port on equipment or piping, and the pre-applied thread sealant helps seal the joint without extra tape.

What tube size do the two push-fit ends accept?

Both push-fit ends accept 10 mm outside-diameter tubing, which is inserted until it bottoms out against the internal grip ring.

How do you install the push-fit connections without leaks?

Cut the 10 mm tube square, deburr the edge, then push it firmly into each port until it stops; the internal collet locks and the O-ring seals automatically.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.