Legris
Legris 3104 62 60 Push-Fit Tee Fitting 1/2 in x 3/8 in Brass
Push-fit tee fitting connects 1/2 in and 3/8 in tubes with brass construction for air applications
- TypeDrain Components
- MaterialHAWA
- ColorBlack
- Push-fit design speeds installation without tools
- Brass body resists corrosion in air-line service
- Mixed 1/2 in and 3/8 in ports join different tube sizes
- Black HAWA composite adds strength and chemical resistance
- Pre-assembled tee simplifies three-way pneumatic routing
Compact Brass Push-Fit Tee
This Legris 3104 62 60 fitting joins three tubing runs in a single brass body. It suits pneumatic circuits where 1/2 in and 3/8 in tubes meet at a T junction. Installers and maintenance teams use it to branch air lines without threading tools.
Tool-Free Branch Connection
Each port accepts push-to-connect tubing so the joint locks by hand. The mixed diameters let a 1/2 in main feed split to a 3/8 in branch while continuing 1/2 in downstream. No sealant tape or wrenches are required, freeing bench time for other assembly steps.
Replaces Threaded Brass Tees
Swapping a threaded tee for this push-fit model removes the need to cut, deburr and thread pipe ends. The upgrade pays off when a system is reconfigured often or when work must proceed in tight cabinets where a wrench cannot swing. It does not suit hydraulic pressures or high-temperature fluids.
Highlights
- Push-fit design speeds installation without tools
- Brass body resists corrosion in air-line service
- Mixed 1/2 in and 3/8 in ports join different tube sizes
- Black HAWA composite adds strength and chemical resistance
- Pre-assembled tee simplifies three-way pneumatic routing
Specifications
| Type | Drain Components |
|---|---|
| Material | HAWA |
| Color | Black |
| Brand | Legris |
| Model | 3104 62 60 |
Questions about this item
What tube sizes does the 3104 62 60 fitting connect?
The tee joins a 1/2 in tube on side A, a 3/8 in tube on side B, and a 1/2 in tube on side C.
Does the brass and fiberglass-reinforced nylon body get hot or noisy during continuous air flow?
The fitting is a passive component with no moving parts, so it generates no noise and negligible heat in normal pneumatic use.
What tubing must I already have to install this push-fit tee?
You need 1/2 in and 3/8 in outer-diameter tubing compatible with push-to-connect fittings for air applications.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
