Legris
Legris 3104 60 62 Push-Fit Tee Fitting 3/8 in x 1/2 in Brass
Connects 3/8 in and 1/2 in tubes with push-fit brass branches for air lines
- TypeDrain Components
- MaterialHAWA
- ColorBlack
- Push-to-connect design speeds installation
- Brass body resists corrosion in air systems
- Mixed 3/8 in and 1/2 in ports suit varied tubing
- Legris 3104 model ensures consistent quality
- Black HAWA finish identifies air-line use
Push-Fit Tee for Air Lines
This brass tee connects three push-to-connect ports for pneumatic tubing. Two ports accept 3/8 in outer-diameter tube and the third accepts 1/2 in tube. The body is brass with fibre-reinforced nylon components and comes without pre-applied thread sealant. It is supplied new for compressed-air plumbing.
Suits Mixed 3/8 in and 1/2 in Tubing
Installers joining 3/8 in and 1/2 in push-fit lines in air systems can use this fitting directly. It is not intended for liquid service, high-temperature fluids or threaded pipe connections. Buyers needing different tube sizes or a threaded branch should select another part.
3/8 in x 1/2 in x 3/8 in Port Combination
The fitting provides two 3/8 in push-to-connect ends and one 1/2 in push-to-connect end in a tee layout. This exact port arrangement determines whether the component matches the tubing plan.
Highlights
- Push-to-connect design speeds installation
- Brass body resists corrosion in air systems
- Mixed 3/8 in and 1/2 in ports suit varied tubing
- Legris 3104 model ensures consistent quality
- Black HAWA finish identifies air-line use
Specifications
| Type | Drain Components |
|---|---|
| Material | HAWA |
| Color | Black |
| Brand | Legris |
| Model | 3104 60 62 |
Questions about this item
What tube sizes does the 3104 60 62 push-fit tee connect?
The 3104 60 62 push-fit tee connects 3/8 in tube on sides A and C, and 1/2 in tube on side B using push-to-connect ends.
What material and colour is the 3104 60 62 fitting body?
The fitting body is brass with a black fibre-reinforced nylon exterior.
How do you install the 3104 60 62 tee and what is the common mistake?
Cut tube square, deburr, then push fully into each port until it stops; the common mistake is not inserting the tube past the grab ring so it can pull out under pressure.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
