We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black push-fit tee fitting with three connections, pack of ten

Legris

Legris 3103 60 14 Male Run Tee 3/8 290 PSI PK10 trap

SKU CH-P88J-H765C MPN 3103

A push-fit male run tee connects two 3/8 inch tubes and a 1/4 inch NPT thread at 290 PSI, supplied in a pack of 10

  • TypeDrain Components
  • MaterialHAWA
  • ColorBlack
  • Push-to-connect ends speed up air-line assembly
  • Male NPT branch with pre-applied sealant cuts thread-prep time
  • 290 PSI rating handles demanding compressed-air systems
  • Fibre-reinforced nylon body resists cutting-fluid exposure
  • Pack of 10 fittings covers multiple connection points

Male Run Tee 3/8" OD

The Legris 3103 60 14 is a push-to-connect male run tee designed for 3/8 inch outer diameter tubing. It features a 1/4 inch MNPT threaded branch with pre-applied thread sealant. The body is constructed from black fiberglass-reinforced nylon.

Suits air and inert gas lines.

This fitting handles compressed air, cutting fluids and inert gases up to 290 PSI. It is not intended for high-temperature hydraulic oil, steam or drinking water systems. Buyers needing stainless steel or brass for corrosive media should look elsewhere.

3/8 inch tube OD with 1/4 inch MNPT branch

The critical specification is the combination of 3/8 inch push-to-connect ends on the run and a 1/4 inch male pipe thread on the branch. Verify both sizes match your tubing and port before ordering.

Highlights

  • Push-to-connect ends speed up air-line assembly
  • Male NPT branch with pre-applied sealant cuts thread-prep time
  • 290 PSI rating handles demanding compressed-air systems
  • Fibre-reinforced nylon body resists cutting-fluid exposure
  • Pack of 10 fittings covers multiple connection points

Specifications

TypeDrain Components
MaterialHAWA
ColorBlack
BrandLegris
Model3103 60 14

Questions about this item

What thread size does the male NPT side use and what pressure does the fitting handle?

The male run tee has a 1/4 inch NPT thread on side C and is rated for 290 PSI operating pressure.

What tube size fits the push-to-connect ends and what is the fitting made of?

Both push-to-connect ports accept 3/8 inch OD tubing and the body is fiberglass-reinforced nylon in black.

How is the tee installed and which step is often missed?

Push the 3/8 inch tubes into sides A and B until they seat, then thread the 1/4 NPT end into the port; the pre-applied sealant means no tape is needed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.