Legend Valve
Legend Valve 450-337 Copper Reducing Tee 4 x 4 x 2
Copper reducing tee connects 4-inch and 2-inch pipes with sweat fittings
- ColorTransparent
- Size4" x 4" x 2"
- TypePipes, Valves & Fittings
- Connects three pipe runs with one fitting
- Reduces flow from 4-inch to 2-inch branch
- Copper construction resists corrosion in plumbing systems
- Sweat connections create permanent leak-resistant joints
- Meets standard dimensions for residential supply lines
Copper Reducing Tee 4 x 4 x 2
The Legend Valve 450-337 is a copper reducing tee designed for plumbing installations. It connects three pipes using sweat solder connections. The fitting reduces from four-inch mains to a two-inch branch. It suits residential and commercial water supply systems.
Capacity and flow reduction
The tee handles standard pressure and temperature ranges for copper piping. The four-inch run provides high-volume flow capacity. The two-inch outlet restricts branch flow compared to the main line. It runs out when branch demand exceeds the two-inch diameter limit.
Sweat solder connection limits
The C x C x C ends require soldering with appropriate flux and lead-free solder. Joint integrity depends on installer skill and pipe preparation. The fitting meets California Proposition 65 warning requirements for chemical content. It cannot be used with press-fit or push-fit systems.
Highlights
- Connects three pipe runs with one fitting
- Reduces flow from 4-inch to 2-inch branch
- Copper construction resists corrosion in plumbing systems
- Sweat connections create permanent leak-resistant joints
- Meets standard dimensions for residential supply lines
Specifications
| Brand | LEGEND VALVE |
|---|---|
| Color | Transparent |
| Size | 4" x 4" x 2" |
| Type | Pipes, Valves & Fittings |
Questions about this item
Will the 4" x 4" x 2" copper tee solder cleanly to my existing 4" and 2" copper lines?
The tee uses C x C x C sweat connections with 4-1/8" OD on the 4" ends and 2-1/8" OD on the 2" end, matching standard copper tube sizes for direct soldering.
How can I verify the Legend Valve 450-337 reducing tee is seated correctly after soldering?
After cooling, pressure-test the joint; a properly soldered tee shows no leaks at the three C x C connections and maintains full bore flow through the 4" run and 2" branch.
Does the 450-337 package include flux, solder or pipe straps, or must I buy them separately?
The box contains only the copper reducing tee; flux, solder and any mounting hardware are not included and must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Scosche
Scosche 8" PRO Midbass Driver 200W RMS 400W Peak 60-8000Hz 97dB 4Ω 3.75" Depth
$9.99
0.00011951BTC
In stock