Legend Valve
Legend Valve 101-425 1 inch S-2000 CXC full port ball valve
A 1-inch forged brass full-port ball valve for air compressor and vacuum pump lines
- Full-port design maximises flow capacity
- Forged brass body resists corrosion and pressure
- 1-inch sweat connections suit copper piping
- S-2000 series built for compressed-air systems
- California Proposition 65 chemical warning applies
Valve for compressed-air systems
The Legend Valve 101-425 is a 1 inch full-port ball valve built for air compressor and vacuum pump installations. It suits technicians and facility managers who need reliable on-off control in pneumatic circuits. The forged brass body resists corrosion in typical workshop environments. This component is not intended for high-pressure hydraulic lines or potable water systems.
1 inch full-port forged brass
The S-2000 designation identifies a forged brass body with a full-port bore that matches the 1 inch nominal pipe size. This specification determines flow capacity and pressure rating for the installation. Buyers must verify that the port size and material match the existing piping before ordering. No other connection standard or alloy is implied by the model number.
Sustained operation in pneumatic service
Under continuous cycling the forged brass construction maintains seal integrity without the deformation seen in cast alternatives. The full-port design minimises pressure drop during extended compressor runs. California Proposition 65 notices apply to chemicals present in the valve materials. The valve ships directly from the manufacturer for orders meeting the 75 threshold.
Highlights
- Full-port design maximises flow capacity
- Forged brass body resists corrosion and pressure
- 1-inch sweat connections suit copper piping
- S-2000 series built for compressed-air systems
- California Proposition 65 chemical warning applies
Specifications
| Brand | LEGEND VALVE |
|---|
Questions about this item
What does the 1 inch full-port rating mean when the valve is installed in a pipe?
The 1 inch full-port design gives an unobstructed bore matching the pipe inside diameter so flow capacity is not reduced at the valve.
What connection standard does the CXC designation indicate and what pressure does it handle?
CXC marks copper sweat ends for soldering to copper tubing and the S-2000 rating confirms a 2000 psi working pressure limit.
What clearance and pipe preparation does a 1 inch sweat-end valve need to fit?
Allow enough straight copper pipe on each side for a proper solder joint and enough space to apply heat without damaging nearby components.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
