We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass mortise electric strike with flat faceplate and auxiliary ramp

Lee Electric

Lee Electric Mortise Flat Face Brass Electric Door Strike 8-16V AC

SKU CH-5ZC1-D34XN

Mortise electric strike with flat brass face operates on 8-16V AC for wood or metal jambs

  • Selling UnitEach
  • Mortise design fits standard door preparations
  • Flat brass face resists corrosion in daily use
  • 8–16 V AC works with common access systems
  • Auxiliary lever ramps suit dead-locking locksets
  • Supports up to 5/8 throw for secure latching

8-16V AC Brass Mortise Strike

The Lee Electric mortise strike accepts 8-16 volt AC power and fits wood or metal jambs. Its flat brass face plate measures 7-15/16 by 1-7/16 inches and the mortise cavity is 1/2 inch deep by 9/16 inch wide by 1-1/2 inches high. A backset of 1-9/16 inches and an auxiliary ramp of 2-7/8 inches suit locksets with up to 5/8 inch throw on a 1/8 inch door gap. Installers needing a different voltage range or a radius face will need another model.

Installation notes

Mortise the jamb to the listed cavity dimensions and secure the strike with the supplied screws; the auxiliary lever ramp aligns automatically with dead-locking latchbolts. A common error is leaving the door gap wider than 1/8 inch, which prevents the 5/8 inch throw from engaging fully. No special tools are required beyond a chisel and drill, but the strike is not designed for surface-mounted or rim-type applications.

Continuous duty behaviour

The coil is rated for intermittent AC energising; holding the strike open continuously will raise coil temperature beyond the design intent. Under normal access-control cycles the brass face and internal mechanism show no measurable wear. Installations that require the strike to remain unlocked for long periods should use a dedicated continuous-duty model instead.

Highlights

  • Mortise design fits standard door preparations
  • Flat brass face resists corrosion in daily use
  • 8–16 V AC works with common access systems
  • Auxiliary lever ramps suit dead-locking locksets
  • Supports up to 5/8 throw for secure latching

Specifications

Selling UnitEach

Questions about this item

How can I verify the strike releases when I apply 8–16 V AC after wiring it?

Apply the rated AC voltage to the coil; the latch bolt should retract smoothly and the auxiliary ramp must clear the lockset’s dead-latching lever without binding.

What comes in the package and which mounting screws or wiring accessories must I source separately?

The box contains the mortise strike body with its flat brass face plate and auxiliary ramp; mounting screws, low-voltage wire and the 8–16 V AC transformer are not included.

Which version should I choose for a lockset with a 5/8-inch throw and a 1/8-inch door gap?

This model is rated for locksets up to 5/8-inch throw based on a 1/8-inch door gap, so it matches those dimensions directly.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.