Lashem
Lashem 24V 6A 120W AC adapter with LED terminal connector 5.5x2.1mm
Converts 100-240V AC to 24V DC at 6A with a 5.5x2.1mm jack and screw-terminal LED connector on a 1.2m cable
- Battery TypeAC Adapters
- Delivers stable 24 V DC at up to 6 A
- Accepts worldwide 100–240 V AC input at 50/60 Hz
- Includes 5.5 × 2.1 mm jack with screw‑terminal LED connector
- Built‑in overload, over‑voltage, over‑temperature and short‑circuit protection
- 2 m cable length for flexible placement
24 V 120 W AC-to-DC adapter
The Lashem adapter converts 100-240 V AC mains power into a regulated 24 V DC output rated at 6 A and 120 W. It is intended for equipment such as LED strips, CCTV cameras, water purifiers, monitors or DC motors that require a stable 24 V supply.
Check voltage polarity and jack size
Verify that your device operates on 24 V DC and draws no more than 6 A. The supplied barrel connector measures 5.5 x 2.1 mm with a centre-positive, outer-negative polarity; mismatched voltage or reversed polarity can damage the connected hardware.
Screw-terminal LED connector simplifies wiring
A 1.2 m input cable reaches standard wall sockets while the included LED terminal block lets you attach bare wires without soldering. Built-in overload, over-voltage, over-temperature and short-circuit cut-offs protect both the adapter and the load during faults.
Highlights
- Delivers stable 24 V DC at up to 6 A
- Accepts worldwide 100–240 V AC input at 50/60 Hz
- Includes 5.5 × 2.1 mm jack with screw‑terminal LED connector
- Built‑in overload, over‑voltage, over‑temperature and short‑circuit protection
- 2 m cable length for flexible placement
Specifications
| Battery Type | AC Adapters |
|---|
Questions about this item
Does the Lashem 24V 6A adapter include the LED terminal connector and DC cable in the box?
Yes, the adapter ships with a 1.2 m DC cable ending in a 5.5×2.1 mm jack and a screw-on LED terminal connector for wire attachment without soldering.
When should I choose the 6 A version instead of a lower-rated 24 V supply?
Choose the 6 A model when your device draws up to 6 A (120 W); it also safely powers loads rated at 5 A, 4 A, 3 A, 2 A or 1 A.
What does the 120 W rating mean for a CCTV camera or LED strip installation?
It means the unit can continuously deliver 24 V at up to 6 A, so a camera or strip drawing less than 120 W will run within the adapter's overload, over-voltage, over-temperature and short-circuit protection limits.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



