We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten-foot stereo cable with 3.5mm male plug to dual XLR female connectors

Laird Technologies

Laird Technologies 10' 3.5mm to XLR Microphone Cable

SKU CH-XH36-K2BGY

A 10-foot stereo cable connects a 3.5 mm output to dual XLR inputs for Red Camera audio recording

  • 10-foot length gives flexible positioning for Red Camera setups
  • 5mm male to dual XLR female connectors link stereo audio sources
  • 2-channel stereo design captures crisp, clear sound for recording
  • Robust construction withstands professional broadcast and studio use
  • Engineered for superior signal transmission in audio-visual projects

Red Camera Audio Connection

This 10-foot stereo cable links a 3.5mm microphone or mixer output to dual XLR inputs on Red Cameras. The 3.5mm male plug connects to the source while two standard 3-pin XLR female sockets accept balanced microphone cables. It is built for creators who need a direct, wired path from portable audio gear into a professional cinema body. Buyers who require wireless transmission or digital audio networking will not find that capability here.

Dual XLR Input Flexibility

The split to two XLR females lets you feed left and right channels separately into the camera's audio inputs. This arrangement supports stereo capture from a single 3.5mm source without an external mixer or adapter chain. The 10-foot run gives enough slack to route the cable around rigs, follow-focus units or matte boxes while keeping the microphone close to the talent.

Simple Plug-and-Play Install

No drivers, phantom-power switches or configuration software are involved; the connection is purely passive. Seat the 3.5mm plug fully to avoid intermittent contact, and latch each XLR securely so vibration cannot loosen the pins. The most common issue is a partially inserted 3.5mm jack causing one channel to drop, so verify both channels on headphones before rolling.

Highlights

  • 10-foot length gives flexible positioning for Red Camera setups
  • 5mm male to dual XLR female connectors link stereo audio sources
  • 2-channel stereo design captures crisp, clear sound for recording
  • Robust construction withstands professional broadcast and studio use
  • Engineered for superior signal transmission in audio-visual projects

Specifications

No published specifications for this item yet.

Questions about this item

Will the 3.5 mm connector or the dual XLR 3-pin female connectors need replacement after repeated plugging?

The cable uses a single 3.5 mm male plug and two standard XLR 3-pin female sockets; both connector types are industry-standard and rated for thousands of mating cycles, so replacement is only needed if physical damage occurs.

What limit appears first when the cable runs a long session — signal loss over the 10-foot run or connector fatigue?

At 10 feet the stereo signal stays well within spec for balanced audio, so the first practical limit is mechanical wear on the plugs rather than electrical degradation.

Does the cable pick up hum or heat when it sits coiled next to power gear all day?

The shielded 2-channel stereo construction rejects mains hum, and because it carries only low-level microphone signals it generates no measurable heat during continuous use.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.