We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Half-inch threaded aluminum conduit elbow powder coated

L.H. DOTTIE

L.H. DOTTIE SLB50 Conduit Elbow 1/2 in Threaded Aluminum Powder Coated

SKU CH-H250-SBPG9

A 1/2 in threaded aluminium conduit elbow with a powder-coated finish for cable management

  • TypeCable Management & Conduit
  • Threaded 1/2 in connection speeds up installation
  • Aluminium body reduces weight for overhead runs
  • Powder-coated finish resists corrosion in damp areas
  • DOTTIE brand trusted by electricians for conduit fittings
  • Condition new ensures clean threads and undamaged coating

1/2 in Threaded Aluminium Elbow

The DOTTIE SLB50 is a conduit fitting designed to join two sections of raceway at an angle. Its powder-coated aluminium body resists corrosion in indoor or outdoor electrical installations. Electricians and maintenance technicians use it to route cables cleanly through walls or ceilings.

Suited for half-inch rigid or IMC conduit

Installers working with 1/2 in threaded conduit will find the threads match standard fittings. The aluminium construction is lighter than steel equivalents, easing overhead work. Projects requiring stainless steel, PVC or larger trade sizes should select a different fitting.

Powder-coated aluminium with Prop 65 notice

The fitting carries a California Proposition 65 warning for chemicals known to cause cancer and reproductive harm. Buyers who need a fitting without this designation must choose an alternative material or finish.

Highlights

  • Threaded 1/2 in connection speeds up installation
  • Aluminium body reduces weight for overhead runs
  • Powder-coated finish resists corrosion in damp areas
  • DOTTIE brand trusted by electricians for conduit fittings
  • Condition new ensures clean threads and undamaged coating

Specifications

BrandDOTTIE
TypeCable Management & Conduit

Questions about this item

How do I install the 1/2 in threaded aluminum elbow and what step causes leaks?

Thread the elbow onto rigid or IMC conduit by hand, then tighten with a strap wrench; the common error is skipping thread sealant or PTFE tape on the 1/2 in NPT threads, which lets moisture enter the raceway.

What maintenance or replacement will the powder-coated aluminum elbow need later?

Inspect the powder coat annually for chips or chalking; if corrosion appears at the threads or the coating fails, replace the fitting — aluminum does not rust but the coating protects against galvanic action.

What limit appears first under sustained thermal cycling?

Repeated expansion and contraction can loosen the 1/2 in threaded joint before the aluminum body fatigues; re-torque the connection after the first few heat cycles to maintain a tight raceway.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.