L.H. DOTTIE
L.H. DOTTIE HW410 Two Hole Strap conduit 4 in Steel Zinc Plated
A two-hole steel strap secures 4-inch conduit with a zinc-plated finish
- TypeCable Management & Conduit
- Secures 4 in conduit with two-hole steel strap
- Zinc-plated finish resists corrosion in damp environments
- DOTTIE brand trusted by electricians for reliable hardware
- Steel construction withstands mechanical stress on pipe runs
- Model HW410 designed for standard conduit pipe use
Two-hole conduit strap for 4 in pipe
This DOTTIE HW410 strap secures 4-inch conduit or pipe runs in electrical installations. The two-hole pattern allows firm attachment to mounting surfaces using appropriate fasteners. Steel construction with zinc plating provides corrosion resistance for indoor or sheltered outdoor use. It is intended for electricians and maintenance crews routing rigid or flexible conduit.
Zinc-plated steel finish and two-hole mounting
The zinc plating protects the steel body from rust in damp environments without adding bulk. Two pre-drilled holes let installers drive screws or bolts directly into framing, strut or junction boxes. No additional brackets or adapters are required; the strap itself forms the complete mounting point. The finish also withstands incidental contact with oils and solvents common on job sites.
Verify conduit outside diameter and fastener length
Confirm that the conduit or pipe you plan to secure matches the 4-inch trade size this strap is designed for. Check that the mounting surface can accept the screw or bolt diameter needed for the two holes. Ensure the fastener length suits the substrate thickness so the strap clamps tightly without bottoming out.
Highlights
- Secures 4 in conduit with two-hole steel strap
- Zinc-plated finish resists corrosion in damp environments
- DOTTIE brand trusted by electricians for reliable hardware
- Steel construction withstands mechanical stress on pipe runs
- Model HW410 designed for standard conduit pipe use
Specifications
| Brand | DOTTIE |
|---|---|
| Type | Cable Management & Conduit |
Questions about this item
Will the zinc plating on this 4 in strap need re-coating after installation?
The zinc plating is applied at the factory and is not designed for field re-coating; if the coating is damaged the strap should be replaced.
What load limit governs how long this steel strap can support a 4 in conduit run?
The strap is rated for the mechanical load of securing 4 in conduit; sustained loads beyond normal conduit weight are not covered by the design.
Does the steel strap generate heat or noise when conduit vibrates all day?
The strap is a passive steel component with no moving parts, so it produces no heat and no audible noise during continuous operation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



