L.H. DOTTIE
L.H. DOTTIE 3/8 in Push-On Nylon Red Conduit Fitting Bushing
3/8 in push-on nylon bushing protects cable in conduit with a red finish for quick identification
- TypeCable Management & Conduit
- 3/8 in push-on fit installs without tools
- Nylon body resists impact and chemical exposure
- Red colour allows quick circuit identification
- Insulating material protects cables from sharp edges
- DOTTIE brand trusted by electricians for conduit accessories
3/8 in Push-On Nylon Bushing
This red nylon conduit fitting bushing accepts a 3/8 inch push-on connection for cable management. It is designed for automotive and general electrical installations where a secure, non-metallic bushing is required. Electricians and vehicle technicians use it to protect wires passing through conduit ends.
Replaces worn or missing bushings
The fitting upgrades from damaged, cracked or absent bushings that leave conduit edges exposed. The jump is worth it when existing bushings no longer grip the conduit or when sharp edges risk cutting insulation during wire pulls. It restores a smooth entry point without changing the conduit run.
Simple push-on installation
Press the bushing onto the conduit end by hand until it seats firmly against the shoulder. The nylon body resists corrosion and does not require thread sealant or tools. What usually goes wrong is selecting the wrong trade size for the conduit, so verify the 3/8 inch dimension before fitting.
Highlights
- 3/8 in push-on fit installs without tools
- Nylon body resists impact and chemical exposure
- Red colour allows quick circuit identification
- Insulating material protects cables from sharp edges
- DOTTIE brand trusted by electricians for conduit accessories
Specifications
| Brand | DOTTIE |
|---|---|
| Type | Cable Management & Conduit |
Questions about this item
Will the 3/8 in push-on bushing fit standard 3/8 in conduit without tools?
Yes, the push-on design slides onto 3/8 in conduit by hand; no threading or tools are required for a secure fit.
What is the correct way to seat the nylon bushing so it does not pull off?
Push the bushing straight onto the conduit end until the internal shoulder bottoms out; twisting while pushing can leave it partially seated.
How often should the red nylon bushing be inspected or replaced in a high-vibration vehicle?
Inspect at every major service interval; replace if the nylon shows cracking, deformation or if the push-on grip feels loose.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



