KuWfi
KuWfi CPE70R 2-Pack 300Mbps 2.4G Outdoor Wireless Range Extender Kit
Two pre-paired 2.4 GHz 300 Mbps outdoor bridges with 12 dBi antennas and passive PoE reach 1 km for cameras
- 300 Mbps wireless speed for bandwidth-intensive tasks
- 12 dBi MIMO panel antenna extends coverage up to 1 km
- Passive PoE on WAN port enables flexible outdoor installation
- LED display shows mode, channel and signal strength
- Multiple AP, Repeater and Bridge modes suit diverse networks
KuWfi CPE70R Outdoor Bridge Kit
The KuWfi CPE70R kit contains two outdoor wireless bridges designed for point-to-point links up to one kilometre. Each unit delivers 300 Mbps over 2.4 GHz 802.11n with a built-in 12 dBi MIMO panel antenna and 28 dBm transmit power. Passive PoE on the WAN port allows installation where mains power is unavailable, and an LED display shows mode, channel and signal strength without opening a web interface.
Suits installers linking buildings or cameras
Ideal for deployments that need a pre-paired bridge pair to connect up to sixteen IP cameras or extend coverage across a property. The H/C hardware switch sets master or slave roles instantly, and AP or repeater modes cover most outdoor scenarios. Not for users who require 5 GHz operation, higher throughput than 300 Mbps, or a single unit to mesh with existing indoor routers.
Check PoE and mounting before ordering
Verify that your switch or injector supplies passive PoE compatible with the WAN port, as active 802.3af/at is not supported. Ensure a clear line of sight between the two mounting points to achieve the rated distance. Confirm the 2.4 GHz band is permitted and not heavily congested at the installation site.
Highlights
- 300 Mbps wireless speed for bandwidth-intensive tasks
- 12 dBi MIMO panel antenna extends coverage up to 1 km
- Passive PoE on WAN port enables flexible outdoor installation
- LED display shows mode, channel and signal strength
- Multiple AP, Repeater and Bridge modes suit diverse networks
Specifications
No published specifications for this item yet.
Questions about this item
What power source do I need to run the CPE70R units?
Each unit is powered through its WAN port using passive Power over Ethernet, so a PoE injector or compatible switch is required.
Will the 2.4G 300Mbps link work with my older 802.11n devices?
Yes, the bridge uses 802.11n Wi-Fi and MIMO, so it is compatible with existing 2.4G 802.11n equipment.
How can I confirm the point-to-point link is healthy after installation?
The built-in LED display shows the operation mode, channel and signal strength for immediate verification.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
