We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass angle stop valve chrome finish CPVC inlet compression outlet

KISSLER AND CO., INC.

KISSLER AND CO., INC. 88-9385 Angle Stop Valve Brass CPVC 1/2 in

SKU CH-4N62-7JRZA

Brass angle stop valve with CPVC inlet and compression outlet rated to 250 psi

  • TypeSingle Hole Faucets
  • Chrome finish resists corrosion for lasting appearance
  • Brass body and stem handle 250 psi pressure rating
  • CPVC inlet simplifies direct plastic-pipe connection
  • Compression outlet seals securely without soldering
  • IAPMO/UPC/SA listing confirms code compliance

Angle Stop Valve for CPVC Supply Lines

The KISSLER & CO 88-9385 angle stop valve controls water flow to fixtures from a CPVC supply line. Its brass body and stem handle 250 psi maximum pressure for residential plumbing. The 1/2 in CPVC inlet connects directly to plastic piping while the 1/4 in compression outlet fits standard supply tubes. IAPMO/UPC/SA listing confirms code compliance.

Brass Construction Handles Pressure and Temperature

All-brass body, stem and handle resist corrosion and withstand hot water temperatures typical in bath installations. The quarter-turn mechanism operates smoothly without hammer or noise under normal pressure. Chrome finish protects the brass exterior from surface oxidation. No electrical components or moving seals require periodic maintenance.

Direct CPVC Connection Simplifies Rough-In

Solvent-weld the 1/2 in CPVC inlet into existing plastic supply lines without adapters or transition fittings. The 1/4 in compression outlet accepts standard risers for faucets or toilets. Angle body style routes supply upward or sideways in tight cavities behind vanities. Valve installs in a single-hole configuration, leaving adjacent stud bays free for other trades.

Highlights

  • Chrome finish resists corrosion for lasting appearance
  • Brass body and stem handle 250 psi pressure rating
  • CPVC inlet simplifies direct plastic-pipe connection
  • Compression outlet seals securely without soldering
  • IAPMO/UPC/SA listing confirms code compliance

Specifications

BrandKISSLER & CO
TypeSingle Hole Faucets

Questions about this item

How do I install the 88-9385 angle stop on the 1/2 in CPVC inlet, and what step is often missed?

Cut the CPVC pipe square, deburr it, apply CPVC cement to both the pipe and the valve socket, push fully home and hold; the step often missed is allowing the joint to cure fully before pressurising the line.

What maintenance or replacement will the brass stem and compression outlet need later?

The brass stem packing may need tightening or replacement if a drip appears at the handle, and the 1/4 in compression ferrule should be replaced whenever the supply line is removed to ensure a leak-free seal.

What limit appears first on the 88-9385 under sustained pressure?

The valve is rated to 250 psi; sustained pressure above that rating will cause the first failure, so the system must stay at or below 250 psi.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.