KINGSTON BRASS
Kingston Brass KS4945CQL Double Lavatory Faucet Oil Rubbed Bronze
A double lavatory faucet in oil-rubbed bronze with brass construction and a 15-inch reach
- FinishOil Rubbed Bronze
- TypeDouble
- Oil Rubbed Bronze finish complements modern bathrooms
- Brass construction resists corrosion for long service life
- 15 3/4 inch reach provides ample clearance at the sink
- 2 Gpm flow rate balances pressure with water conservation
- Contemporary design suits a wide range of décor styles
Double-Handle Lavatory Faucet
The Kingston Brass KS4945CQL is a double-handle lavatory faucet finished in oil-rubbed bronze. It suits bathrooms where separate hot and cold controls are preferred. The brass construction provides structural rigidity for daily use. This model fits standard three-hole lavatory installations.
Brass Build with 15-3/4 Inch Reach
Brass construction resists corrosion and handles repeated valve operation without flex. The 15-3/4 inch spout reach extends well over the basin, reducing splash-back toward the countertop. A decorative flange covers the mounting holes for a clean appearance. No escutcheon plate is required for installation.
2.2 GPM Flow Rate Determines Suitability
The faucet delivers a fixed 2.2 gallons per minute flow rate through a single normal spray pattern. Buyers who need a lower flow rate for water-restricted regions or a higher flow for rapid filling should choose a different model. There is no pull-out spray, side spray or soap dispenser included.
Highlights
- Oil Rubbed Bronze finish complements modern bathrooms
- Brass construction resists corrosion for long service life
- 15 3/4 inch reach provides ample clearance at the sink
- 2 Gpm flow rate balances pressure with water conservation
- Contemporary design suits a wide range of décor styles
Specifications
| Brand | Kingston Brass |
|---|---|
| Finish | Oil Rubbed Bronze |
| Type | Double |
Questions about this item
What fitting standard does the Kingston Brass KS4945CQL double lavatory faucet use, and what flow rate does it cap at?
It connects with standard US 1/2-inch IPS supply lines and the aerator limits flow to 2.2 Gpm at 60 psi.
What mounting dimensions and clearance does the faucet need?
The spout reaches 15-3/4 inches from the deck and each handle requires a 1-3/8 inch hole on 8-inch centres; allow 2 inches behind the deck for supply nuts.
How is the faucet installed, and which step is often missed?
Place the decorative flange and rubber gasket on the deck, insert the shanks through the holes, tighten the mounting nuts from below, then connect the hot and cold supply lines to the correct shanks — reversing them is the common error.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



