We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Gray powder-coated iron conduit elbow, threaded half-inch female ends, compact right-angle shape

Killark

Killark Y-1M IMC Elbow 1/2 in Threaded Iron Powder Coated Gray

SKU CH-4EYQ-P1JQB

A hazardous-location capped elbow joins two half-inch IMC or threaded rigid conduits with female NPT threads and a powder-coated iron finish

  • TypeCable Management & Conduit
  • Hazardous-location rated for Class I, II, III Division 1 & 2 environments
  • Powder-coated iron construction resists corrosion in harsh industrial settings
  • Female-to-female threaded ends connect IMC conduit without adapters
  • Compact 2 7/8 in length fits tight conduit runs
  • Weighs .79 lb for easy handling and installation

Killark IMC Elbow 1/2 in Threaded

This capped elbow connects two sections of 1/2 inch IMC or threaded rigid conduit in hazardous locations. The female-to-female NPT ends accept standard threaded fittings. It is built from iron with a powder-coated gray finish for corrosion resistance in industrial environments.

Hazardous Location Rating and Durability

The fitting carries Class I Division 1 and 2 ratings for Groups C and D, Class II Division 1 and 2 for Groups E, F, and G, and Class III Division 1 and 2. The powder-coated iron body withstands harsh conditions without active cooling or power requirements.

1/2 in Female NPT Threaded Ends

The decisive specification is the 1/2 inch FNPT by FNPT thread configuration. Buyers needing a different trade size, male threads, or a non-hazardous location fitting must select another product.

Highlights

  • Hazardous-location rated for Class I, II, III Division 1 & 2 environments
  • Powder-coated iron construction resists corrosion in harsh industrial settings
  • Female-to-female threaded ends connect IMC conduit without adapters
  • Compact 2 7/8 in length fits tight conduit runs
  • Weighs .79 lb for easy handling and installation

Specifications

BrandHUBBELL KILLARK
TypeCable Management & Conduit

Questions about this item

How do I install the Killark Y-1M IMC elbow correctly, and what step do people often miss?

Thread each 1/2 in FNPT end onto IMC or threaded RMC conduit until tight, then apply approved sealant to the joints; the step often missed is using a listed hazardous-location sealing compound to maintain the Class I Division 1 rating.

What maintenance or replacement will this fitting need over time?

The powder-coated iron body resists corrosion, so no routine maintenance is required; replace the elbow only if physical damage, thread wear, or coating breach compromises the hazardous-location seal.

What limit appears first when this elbow is used continuously in a hot, hazardous area?

The 0.79 lb iron casting and powder coating set the thermal and mechanical limit; sustained heat or vibration that degrades the coating or threads will reduce the Class I Division 1 Groups C D integrity before any other factor.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.