Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00933145BTC
In stock
Killark
Killark MOLBD-1M Conduit Outlet Body LB 1/2 in
A 1/2 in LB conduit outlet body with 15.2 cu in capacity, powder-coated iron construction, and included cover and gasket for IMC and RMC conduit
- TypeCable Management & Conduit
- LB body enables 90-degree conduit turns
- Powder-coated iron resists corrosion
- 2 cu in capacity fits multiple conductors
- Threaded hubs accept IMC and RMC conduit
- Includes cover and gasket for sealed installation
Electrical conduit outlet body
The Killark MOLBD-1M is a conduit outlet body designed for electrical raceway systems. It provides a 90-degree directional change for threaded rigid metal conduit or intermediate metal conduit. The gray powder-coated iron housing includes a flat back and a cover with gasket for a sealed installation. It offers 15.2 cu in of internal wiring capacity.
Installers working with 1/2 in trade size raceways
This fitting suits electricians pulling conductors through IMC or RMC systems where a smooth 90-degree turn is required. The threaded hubs and included cover simplify assembly in dry locations. It is not intended for hazardous-location installations or for use with non-metallic conduit types such as PVC or flexible metal conduit.
Performance under sustained load
The iron construction and powder-coated finish resist corrosion and mechanical stress during continuous operation. Threaded connections maintain secure conduit alignment when exposed to vibration or thermal cycling. The 15.2 cu in volume allows heat dissipation for the conductors housed inside without exceeding fill limits.
Highlights
- LB body enables 90-degree conduit turns
- Powder-coated iron resists corrosion
- 2 cu in capacity fits multiple conductors
- Threaded hubs accept IMC and RMC conduit
- Includes cover and gasket for sealed installation
Specifications
| Brand | HUBBELL KILLARK |
|---|---|
| Type | Cable Management & Conduit |
Questions about this item
What conduit trade size must my existing raceway be for this 1/2 in LB body to thread on directly?
The body accepts 1/2 in trade size IMC or RMC conduit, so your raceway must be 1/2 in trade size for a direct threaded connection.
Will the 15.2 cu in capacity of this LB body accommodate the same conductor fill as my older 1/2 in LB fittings?
This body provides 15.2 cu in of internal volume; compare that figure to the cubic-inch rating marked on your older fittings to confirm equivalent or greater fill allowance.
How can I verify the powder-coated gray finish and included gasket are sealing properly after installation?
Inspect that the flat back sits flush against the mounting surface, the threaded hubs engage fully, and the supplied gasket compresses evenly under the included cover for a tight seal.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
