KICKER
KICKER CompRT 10" Subwoofer Pair + CXA8001 800W Amp
Two 10-inch CompRT subwoofers with a mono Class D amplifier delivering 800 watts RMS at 1 ohm in a shallow-mount design
- TypeSubwoofers
- 800 watts RMS drives deep bass from a mono Class D amp
- 600 watts at 2 ohms and 300 watts at 4 ohms give flexible wiring
- Two 10-inch CompRT subs with dual 2-ohm coils fit shallow enclosures
- 400 watts RMS each sub handles high output with forced-air cooling
- 25–500 Hz response and 84.8 dB sensitivity deliver accurate low-frequency output
Bundle contents
This package pairs two KICKER CompRT 10" subwoofers with a CXA8001 mono Class D amplifier. Each subwoofer uses a dual 2-ohm voice coil and handles 400 watts RMS. The amp delivers 800 watts RMS at 1 ohm, 600 watts at 2 ohms and 300 watts at 4 ohms.
Who it suits and who it doesn't
The shallow 3-7/16 inch mounting depth fits tight enclosures where standard drivers will not. Installers who need a compact, high-output bass system with remote level control will benefit. Buyers who want more storage or a full-range speaker solution should look elsewhere.
Capacity and headroom
Frequency response spans 25 to 500 Hz with 84.8 dB sensitivity at 1 watt. The amplifier accepts up to 40-volt input signals and includes a 12 dB crossover plus 6 dB bass boost. At 1 ohm the amp reaches its 800-watt limit; higher impedance loads reduce available power.
Highlights
- 800 watts RMS drives deep bass from a mono Class D amp
- 600 watts at 2 ohms and 300 watts at 4 ohms give flexible wiring
- Two 10-inch CompRT subs with dual 2-ohm coils fit shallow enclosures
- 400 watts RMS each sub handles high output with forced-air cooling
- 25–500 Hz response and 84.8 dB sensitivity deliver accurate low-frequency output
Specifications
| Type | Subwoofers |
|---|
Questions about this item
What power and ground wiring does the CXA8001 800-watt amp need to deliver 800 watts RMS at 1 ohm?
Run 4 AWG power and ground leads with an 80-amp fuse near the battery to support the amp's 800-watt RMS rating at 1 ohm.
Will the 10-inch CompRT subwoofers fit behind the rear seat of my extended-cab truck with only 5 inches of depth available?
Yes, each CompRT 10-inch driver has a mounting depth of 3-7/16 inches, leaving clearance in a 5-inch cavity.
How do I verify the CXA8001 amp is delivering clean 800-watt output after installation?
Set the subsonic filter near 25 Hz, adjust the 12 dB crossover, then confirm the remote bass knob changes output smoothly without distortion at full volume.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
PAC APH-TY02 Speaker Connection Harness Toyota Lexus 18
- Car Stereo Add-Ons
The Wires Zone Platinum 1/0 AWG Ring Terminals Pair
- Connector and Termi…



