KHACHIMO
KHACHIMO Vapel Power Supply DAR400-4812A ATX
ATX power supply for Vapel DAR400-4812A systems, tested working and new condition
- TypeATX
- ATX form factor fits standard PC cases
- Tested working before shipment for reliable operation
- Good quality components support stable power delivery
- Designed for Vapel DAR400-4812A systems
- First listed by manufacturer March 26 2024
KHACHIMO Vapel DAR400-4812A ATX Power Supply
This ATX power supply is built for Vapel systems using the DAR400-4812A model. It suits repair technicians and owners replacing a failed unit in compatible hardware. The unit is new and tested working before dispatch.
Straightforward ATX Installation
Installation follows standard ATX mounting and cabling routines used in compatible Vapel chassis. The tested-working status reduces the risk of a dead-on-arrival unit. The main difficulty arises if the target system uses a non-standard pin-out or proprietary connector not covered by the ATX form factor.
400 W Capacity for Compatible Vapel Loads
The 400 W rating delivers adequate headroom for the original Vapel configuration this unit was designed to support. It runs out when the system demands exceed the rated output or when additional components draw more current than the original specification allows.
Highlights
- ATX form factor fits standard PC cases
- Tested working before shipment for reliable operation
- Good quality components support stable power delivery
- Designed for Vapel DAR400-4812A systems
- First listed by manufacturer March 26 2024
Specifications
| Type | ATX |
|---|
Questions about this item
How can I confirm the 400W ATX unit is working after installation?
Power on the system and verify stable voltages through the BIOS hardware monitor or a software utility; the unit was test-working before shipment.
What comes with the DAR400-4812A power supply and what must I source separately?
The power supply itself is included; ATX power cables, mounting screws and any adapters required for your specific Vapel chassis are not supplied.
Which capacity should I choose for a Vapel build needing a 400W ATX replacement?
The DAR400-4812A is a single 400W ATX model listed in March 2024, so select this version when your Vapel system specifies that exact rating.
New to this? Buying PC parts with Monero — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
minisforum MF-SRP01 SSD Heatsink accessories barebone
- SSD Heatsink
Intel HNS2600BPS24R 2U barebone pc dual Xeon DDR4 2.80 TB C622
- Xeon Bronze Xeon Go…
- DDR4-2933/PC4-23466



