Keyence Car Vent Phone Mount Drop-in Grip

Drop-in Grip Vent Mount

This car vent phone mount uses a gravity-operated drop-in grip that clamps the phone automatically when you slide it in. No buttons or levers are required, so you can place or remove the device with one hand while keeping the other on the wheel. The design is intended for drivers who want the fastest possible docking action without fiddling with mechanical arms.

Upgrade From Spring-Loaded Cradles

Unlike older spring-loaded or button-release holders, this mount removes the need to squeeze arms or press a release every time you dock the phone. The jump is worth it if you frequently enter and exit the vehicle and want to avoid the delay of resetting navigation after a fiddly placement. The three-point hook also solves the common issue of the whole mount slipping off the vent on bumps or sharp turns.

Fits Phones Up To 4.7 Inches And 14 Mm Thick

The clamp opening spans .5 to 1.41 inches, so it accommodates devices up to roughly 4.7 inches wide with a case no thicker than 14 mm. It does not fit round air vents, and the holder only supports vertical orientation. Larger phones such as the 15, 16, 17 or 26 series models will exceed the width limit, and any device thicker than the stated maximum will not seat securely.