Keson Industries
Keson Industries PGT8MV 8 m tape measure 25 mm orange
An 8 m tape measure with a 25 mm blade, metric graduations, toggle lock and automatic rewind in an orange case
- Length5.000
- Width1.750
- MaterialHAWA
- TypeLong
- 8 m blade covers long spans with a single pull
- 25 mm wide blade stays rigid for clear readings
- Metric graduations give direct cm and mm values
- Toggle lock holds the tape firmly at any length
- Automatic rewind retracts the blade quickly and smoothly
Tape measure for large-area work
This Keson PGT8MV tape measure has an 8 m blade with a 25 mm width for measuring long distances. Metric graduations show metres, centimetres and millimetres on the blade. An orange case protects the tape when it is not in use. A toggle lock holds the blade steady while you work.
Manual operation with automatic rewind
The tape extends and retracts by hand without a motor or battery. An automatic rewind system pulls the blade back into the case without difficulty. No power draw or fan noise is involved in normal use. The tool is ready whenever you need it.
Replaces shorter tapes or folding rules
It upgrades from pocket tapes that run out before the job is done. The 8 m reach covers room spans and outdoor layouts in one pull. Buyers who need more than 8 m of continuous measurement will need a longer model. The jump is worth it when you regularly measure past the length of a standard short tape.
Highlights
- 8 m blade covers long spans with a single pull
- 25 mm wide blade stays rigid for clear readings
- Metric graduations give direct cm and mm values
- Toggle lock holds the tape firmly at any length
- Automatic rewind retracts the blade quickly and smoothly
Specifications
| Brand | KESON |
|---|---|
| Length | 5.000 |
| Width | 1.750 |
| Material | HAWA |
| Type | Long |
Questions about this item
How do I extend the 25 mm blade and lock it so it does not retract while I measure?
Pull the blade out to the required length, then engage the toggle lock to hold the 25 mm tape in place; release the lock before allowing the automatic rewind to retract the blade smoothly.
What part of the 8 m tape measure is most likely to need replacement after heavy use?
The 25 mm steel blade and the internal rewind spring are the components that wear first; the orange case protects the mechanism but the blade markings can fade and the spring can lose tension over time.
At what point does the 25 mm blade start to sag when I measure long spans unsupported?
The 25 mm wide blade will begin to bow under its own weight beyond roughly 2 to 3 metres of unsupported extension, so keep the tape braced or use a helper for the full 8 m reach.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
