We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Plunger door holder, cast zinc, silver finish, door-mount, rubber tip

Kaba Ilco Corp

Kaba Ilco Corp Plunger Door Holder Cast Zinc Sliver 7-3/4"H x 1-5/8"W

SKU CH-66G9-FWSSP

A plunger door holder in cast zinc with a silver finish, rubber tip and included hardware for door mounting

  • TypeDoor Hardware & Components
  • Secure hold with rubber-tip plunger design
  • Cast zinc body resists daily wear
  • Door-mount installation suits standard entries
  • 11/16 in base fits tight clearances
  • Hardware included for quick setup

Plunger Door Holder for Door-Mount Use

This Kaba Ilco Corp plunger door holder mounts directly on the door to hold it open. The cast zinc body with a clear aluminum finish suits residential or light commercial entrances. Hardware is included for installation. Buyers who need a wall-mounted stop or a magnetic catch should look elsewhere.

Sustained Use with Rubber Tip

The rubber tip cushions repeated contact so the holder absorbs daily impacts without marring the floor. Bronze material in the mechanism resists wear from frequent plunger cycles. The 1 1/4 in projection keeps the door clear of trim during long-open periods. No hydraulic or spring-assisted damping is provided.

7-3/4" Height Fits Standard Doors

At 7 3/4 in tall and 1 5/8 in wide, this holder aligns with common door hardware placement. The 11/16 in base diameter secures firmly to the door face. Verify the projection and height match your door clearance before ordering. This single dimension set determines fit.

Highlights

  • Secure hold with rubber-tip plunger design
  • Cast zinc body resists daily wear
  • Door-mount installation suits standard entries
  • 11/16 in base fits tight clearances
  • Hardware included for quick setup

Specifications

BrandKABA ILCO
TypeDoor Hardware & Components

Questions about this item

Does the plunger door holder generate any noise, heat or draw power when it stays engaged all day?

No, it is a purely mechanical spring-loaded catch with no motor or electronics, so it runs silently and without heat or power draw.

What must already be on the door for the included hardware to mount this holder?

The kit supplies screws for a standard door-mount installation; you only need a pre-drilled pilot hole in the door face.

Will the 7-3/4 inch height and 1-5/8 inch width interfere with an existing mortise lock or closer arm on the same door?

The slim 1-5/8 inch projection and door-mount base leave ample clearance for most mortise locks and surface closers already fitted.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.