K&E Safety
K&E Safety M490-LED DCBP Blue Strobe Light Kit
Blue LED strobe kit with three flash rates, IP67 rating and 26,000-hour lamp life
- Blue LED strobe delivers high visibility
- Three flash rates — 63, 80 or 120 per minute
- IP67 rating resists dust and water ingress
- Operates from 12 to 90 V DC power sources
- Long-life LED rated for 26,000 hours of use
Product Overview
The K&E Safety M490-LED DCBP is a blue LED strobe light kit designed for warning and signalling applications. It operates on a wide 12 to 90V DC power range, drawing between 0.18 and 0.24 amps. The unit is rated IP67 for dust and water ingress protection.
Build Integration
The light features a screw mounting base and requires a wired DC power source within the specified voltage range. Its ABS housing and polycarbonate dome lens suit interior or exterior mounting where a 3 by 3 inch footprint is available. The wide voltage input frees the installer from needing a specific regulated supply.
Thermals and Power
The LED lamp is rated for a 26,000 hour service life. The unit functions across an operating temperature span of -30 to 50 degrees Celsius. With a low current draw of 0.18 to 0.24 amps, it imposes minimal load on the electrical system during continuous flashing operation.
Highlights
- Blue LED strobe delivers high visibility
- Three flash rates — 63, 80 or 120 per minute
- IP67 rating resists dust and water ingress
- Operates from 12 to 90 V DC power sources
- Long-life LED rated for 26,000 hours of use
Specifications
| Brand | RAILHEAD GEAR |
|---|
Questions about this item
Does the 12-90V DC input limit how long the M490-LED DCBP can run continuously?
The unit is rated for continuous operation from -30 to 50 °C with an IP67 housing, so the voltage range itself does not impose a run-time limit.
How much heat or noise does the strobe produce when powered all day at 0.18-0.24 A?
LED lamp draws 0.18 to 0.24 A, runs silently with no moving parts, and the ABS housing stays cool enough for the full -30 to 50 °C ambient range.
What mounting hardware must I already have to install the screw-mount base?
The kit uses a screw mount; you need a flat surface and the appropriate screws or bolts for that surface, which are not included.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



