JVC
JVC DLA-RS30 BHL5010-S Genuine Compatible projector lamp 200W 2000 Hrs
A ready-to-install 200 W UHP lamp module rated for 2,000 hours of projector use
- TypeProjector Lamp
- Wattage200W
- Lamp Life2,000 Hrs.
- Genuine compatible module fits JVC DLA-RS30 directly
- 200 W UHP bulb delivers rated brightness
- 2 000-hour lamp life supports extended use
- Pre-assembled housing enables quick tool-free installation
- Manufactured to ISO 9001 quality standards
Direct-fit replacement for JVC DLA-RS30
This new projector lamp module ships as a fully assembled 200 W UHP bulb inside its housing. It matches the original BHL5010-S specifications so the installer can swap the unit without extra tools or alignment steps. The lamp is rated for 2 000 hours of operation under standard projector use.
Replaces a dimmed or failed original lamp
When the existing module reaches the end of its rated life or suffers a premature burnout, this unit restores the projector to its factory brightness and colour balance. The upgrade is worthwhile whenever the current lamp shows noticeable lumen drop, colour shift or an on-screen replacement warning.
Maintains steady output through extended sessions
Each module is tested to ISO 9001 criteria for beam performance, ignition voltage and run-time consistency. The 200 W UHP design delivers stable light output during long presentations or film marathons without the flicker or hot-spot drift that can appear with unqualified alternatives.
Highlights
- Genuine compatible module fits JVC DLA-RS30 directly
- 200 W UHP bulb delivers rated brightness
- 2 000-hour lamp life supports extended use
- Pre-assembled housing enables quick tool-free installation
- Manufactured to ISO 9001 quality standards
Specifications
| Brand | JVC |
|---|---|
| Type | Projector Lamp |
| Wattage | 200W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Does the BHL5010-S lamp module come with the housing already attached?
The module ships as a fully assembled unit with the 200W UHP bulb inside its housing, so no separate assembly is required before fitting it into the projector.
What is the correct sequence for resetting the lamp timer after installing this module?
Power on the projector, open the menu, select the lamp-reset option and hold the confirm button until the counter clears; skipping the reset leaves the old hour count active.
How many hours of use can I expect before the 200W UHP bulb reaches its rated end of life?
The lamp is rated for 2,000 hours of operation; plan a replacement when the projector's hour counter approaches that figure.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



