Juno Lighting
Juno Lighting Track Fixture Open Back 50W 120V light fixture
Open-back track head accepts GU10, MR16 or PAR16 lamps up to 50 W at 120 V
- Gimbaled head directs light precisely where needed
- Open-back design fits GU10, MR16 and PAR16 lamps
- 50 W maximum handles bright halogen, incandescent or LED sources
- 120 V AC input works on standard track systems
- Steel housing in white finish resists heat and wear
Juno Track Fixture Open Back 50W
This Juno Lighting track head accepts GU10, MR16 or PAR16 lamps up to 50 watts at 120 volts AC. Its open-back steel housing fits standard track systems and suits retail displays, gallery walls or residential accent lighting where a compact, adjustable head is required.
Replaces fixed halogen heads
Swapping sealed halogen units for this gimbaled head lets you aim light precisely and choose LED, halogen or incandescent lamps per project needs. The upgrade is worthwhile when beam direction must change seasonally or when lower-energy LED lamps replace higher-wattage halogen originals.
Fits single-circuit track
The fixture mounts directly to compatible Juno Trac-Lites track and operates on 120-volt circuits without a separate transformer. Its shallow 2-1/2 inch length and 2-1/8 inch diameter keep the profile tight to the ceiling, freeing vertical clearance for low soffits or shelving.
Highlights
- Gimbaled head directs light precisely where needed
- Open-back design fits GU10, MR16 and PAR16 lamps
- 50 W maximum handles bright halogen, incandescent or LED sources
- 120 V AC input works on standard track systems
- Steel housing in white finish resists heat and wear
Specifications
| Brand | Juno Lighting Group - Juno Trac-Lites |
|---|
Questions about this item
Does the 2 1/8 in diameter head fit standard Juno Trac-Lites track?
Yes, the fixture is built for Juno Trac-Lites track and the 2 1/8 in diameter housing mounts directly onto that system without adapters.
How do I secure the GU10 or MR16 lamp so it does not loosen over time?
Insert the lamp into the GU10 or MR16 socket, then twist until the base locks; the open-back steel housing gives finger room to confirm the lamp is fully seated.
When the 50 W halogen lamp fails, can I replace it with an LED equivalent?
The socket accepts GU10, MR16 or PAR16 lamps up to 50 W, so a compatible LED retrofit of equal or lower wattage can be used as a direct replacement.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
