Juno Lighting
Juno Lighting R25 BL T-Connector Black 4 1/8in DLP Replacement Lamp
A black T-connector for single-circuit J-style track lighting, rated 20 A at 120 V AC and cULus listed
- TypeTraffic & Parking Lot
- T-Connector design enables flexible track layouts
- cULus listed certification confirms electrical safety compliance
- 120 V AC rating suits standard North American power
- 2,400 W maximum capacity supports high-output fixtures
- Black plastic housing blends with Juno Track Style J systems
Juno R25 T-Connector for Track J
The Juno R25 BL T-Connector joins two sections of Juno Track Style J in a straight line. It carries a single 120 V AC circuit rated at 20 A and up to 2 400 W. The black plastic housing matches the track finish and is cULus listed for indoor use. Installers use it to extend continuous runs of track lighting in commercial or residential spaces.
Thermals noise and power draw
The connector is a passive component with no fan, motor or active electronics. It generates no audible noise and draws no power of its own. Heat dissipation depends entirely on the connected track heads and the load they place on the 20 A circuit. Normal operation adds no measurable thermal load to the track system.
Single-circuit 20 A capacity
This T-Connector supports only one electrical circuit, so every fixture on the combined run shares the same 20 A limit. Projects that require independent switching or dimming zones need a multi-circuit connector instead. The 4 1/8 in length fits standard Track Style J spacing without adapters.
Highlights
- T-Connector design enables flexible track layouts
- cULus listed certification confirms electrical safety compliance
- 120 V AC rating suits standard North American power
- 2,400 W maximum capacity supports high-output fixtures
- Black plastic housing blends with Juno Track Style J systems
Specifications
| Brand | JUNO LIGHTING GROUP - JUNO TRAC-LITES |
|---|---|
| Type | Traffic & Parking Lot |
Questions about this item
How is the T-Connector installed and which step is often missed?
Snap the T-Connector into a J-style track, then tighten the set screws to lock the single 120 V circuit — the step most people skip is verifying the screws are fully seated so the 20 A contact stays secure.
What maintenance or replacement will the T-Connector need later?
The plastic housing and copper contacts are rated for 2,400 W maximum load; inspect yearly for discoloration or loose fit and replace the unit if the housing cracks or the blades show pitting.
What limit appears first during sustained use?
The 20 A / 2,400 W rating is the first ceiling — running near that level continuously will heat the plastic housing to its design limit before any other component fails.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



