JB Industries
JB Industries CLS-60Y HVAC Control Hose 60 In Yellow
Low-loss rubber-and-Kevlar hose with 45-degree brass fittings for refrigerant charging and evacuation, rated to 800 psi working pressure
- ColorYellow
- Low-loss design keeps refrigerant in the system
- 60 in length gives ample reach for service jobs
- 800 psi working pressure handles demanding charging tasks
- 4,000 psi burst rating provides a wide safety margin
- Yellow colour allows quick visual identification on the job
HVAC Charging and Evacuation Hose
The JB Industries CLS-60Y is a low-loss hose built for refrigerant charging and evacuation tasks. It suits technicians who need a single, dedicated line for service work. The 60-inch length gives reach across engine bays or equipment panels. Secure Seal fittings help prevent refrigerant escape during connection and disconnection.
Thermals Noise and Pressure Performance
Rubber and Kevlar construction handles a working pressure of 800 psi with a burst rating of 4,000 psi. Brass fittings resist corrosion from common refrigerants and oils. The 45-degree angle on the 1/4-inch female fitting eases routing in tight service ports. No electrical components are present, so the hose adds no noise or power draw to the job.
Replaces Worn or Standard Service Hoses
This hose upgrades from cracked, permeable rubber lines that leak charge over time. The Kevlar reinforcement reduces hose expansion under load for more accurate gauge readings. It is not for technicians who need multiple hoses in a manifold set or who require different fitting angles for specific OEM ports. The yellow colour identifies the line at a glance during busy service calls.
Highlights
- Low-loss design keeps refrigerant in the system
- 60 in length gives ample reach for service jobs
- 800 psi working pressure handles demanding charging tasks
- 4,000 psi burst rating provides a wide safety margin
- Yellow colour allows quick visual identification on the job
Specifications
| Brand | JB INDUSTRIES |
|---|---|
| Color | Yellow |
Questions about this item
How do I install the 45-degree brass fitting on this 60-inch yellow hose without cross-threading it?
Thread the 1/4-inch female fitting by hand until the brass seats flush, then tighten an additional quarter-turn with a wrench; the Secure Seal design prevents leaks when the angle is fully seated.
What maintenance will the rubber and Kevlar hose need after repeated refrigerant charging cycles?
Inspect the yellow cover for abrasion or oil swelling after each job; replace the hose if the Kevlar reinforcement becomes visible or if the brass fitting shows corrosion.
At what pressure does the hose reach its safety limit during a long evacuation pull?
The working pressure is 800 psi; sustained vacuum or charge sessions should stay well below that level because the burst rating is 4,000 psi.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
