We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass sillcock with plastic handwheel handle 1/2 inch inlet

Jay R. Smith Mfg. Co

Jay R. Smith Mfg. Co 560-10 Sillcock 1/2 in ABS bathware

SKU CH-GE7M-Z58F1

A 1/2-inch threaded sillcock with brass body and plastic handwheel handle meets AB1953, NSF/ANSI 61-2008 and ASSE 1011 standards

  • TypeOther
  • Lead-free brass body meets AB1953 and NSF/ANSI 61-2008
  • ASSE 1011 certified for anti-siphon backflow protection
  • IAPMO listed confirming code-compliant installation
  • Half-inch threaded inlet fits standard supply lines
  • Durable plastic handwheel handle resists corrosion

1/2 in Threaded Sillcock

The Jay R. Smith 560-10 sillcock provides a 1/2 in threaded inlet for standard plumbing connections. Its brass body and plastic handwheel handle suit residential and light commercial bathware installations. The valve meets AB1953 lead law requirements and NSF/ANSI Standard 61-2008 for drinking water safety. It is IAPMO listed under File No 3770 for code compliance.

Standards-Listed Brass Construction

The brass body resists corrosion under normal water pressure and temperature ranges. Plastic handwheel operation requires low torque and produces minimal noise during opening and closing cycles. No electrical power is needed, so standby draw is zero. ASSE 1011 listing confirms performance for backflow prevention in typical supply conditions.

Code-Ready Compliance Package

IAPMO listing and NSF/ANSI 61-2008 certification streamline permit approvals for potable water lines. AB1953 compliance satisfies lead-content restrictions in regulated jurisdictions. ASSE 1011 marking identifies the device as a tested anti-siphon sillcock for inspector verification. No additional accessories or software are bundled with the valve.

Highlights

  • Lead-free brass body meets AB1953 and NSF/ANSI 61-2008
  • ASSE 1011 certified for anti-siphon backflow protection
  • IAPMO listed confirming code-compliant installation
  • Half-inch threaded inlet fits standard supply lines
  • Durable plastic handwheel handle resists corrosion

Specifications

BrandSMITH LIGHT COMMERCIAL
TypeOther

Questions about this item

How do I install the 560-10 sillcock and what step is often missed?

Thread the 1/2 in inlet into the supply line using pipe sealant, then tighten with a wrench on the brass body flats — do not force the plastic handwheel or you will crack it.

What part of the 560-10 sillcock will need replacement first?

The plastic handwheel handle can become brittle after years of UV exposure and seasonal temperature swings; the brass body and internal seat typically outlast it.

What limits the 560-10 sillcock during a long freeze-thaw cycle?

The ABS bathware body meets ASSE 1011 and NSF/ANSI 61-2008, but the plastic handwheel and internal seals set the practical temperature limit before the brass inlet does.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.