Jaspertronics
Jaspertronics S320-LAMP dlp replacement lamp 320
Replacement lamp and housing module for the Dell S320 projector with original-specification bulb
- TypeProject Lamp
- Weight0.9990
- Original-spec lamp restores full brightness and clarity
- Complete housing module enables direct swap without extra parts
- Built for Dell S320 projector for guaranteed compatibility
- New condition delivers full rated lifespan from first use
- One-year warranty backs reliable long-term operation
Perfect Fit for Dell S320
This replacement lamp module is built specifically for the Dell S320 projector. It delivers original-specification brightness and clarity so presentations and media look as intended. The unit arrives new and ready to install without additional parts.
Original Components in a Complete Housing
The lamp ships inside its original housing, so you simply swap the entire module rather than handling a bare bulb. Authentic internal components maintain the projector’s factory colour balance and light output. A one-year warranty backs the build quality.
Verify Your Projector Model Before Ordering
Confirm the unit is a Dell S320; this module will not fit other Dell projectors or third-party models. No tools or firmware updates are required for installation. Buyers needing a bare bulb without the housing should look for a different part.
Highlights
- Original-spec lamp restores full brightness and clarity
- Complete housing module enables direct swap without extra parts
- Built for Dell S320 projector for guaranteed compatibility
- New condition delivers full rated lifespan from first use
- One-year warranty backs reliable long-term operation
Specifications
| Brand | Jaspertronics |
|---|---|
| Model | S320-LAMP |
| Part Number | S320-LAMP |
| Type | Project Lamp |
| Weight | 0.9990 |
Questions about this item
What projector model does the S320-LAMP lamp and housing module fit?
The S320-LAMP module is built for the Dell S320 projector and matches the original lamp specifications.
Does the S320-LAMP assembly include the housing, or must the bare bulb be fitted into the old cage?
It arrives as a complete lamp-and-housing unit, so the old cage does not need to be reused.
Is any alignment or calibration step required after installing the S320-LAMP module?
Install the module, reset the projector's lamp timer through the menu, and the unit is ready — no further calibration is needed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Viking Electronics K-1500-6A Panel Telephone
- Viking Vandal Resis…



