Jaspertronics iQ400-Series-SINGLE-LAMP dlp replacement lamp

Direct replacement for Barco iQ400 Series

This Jaspertronics lamp and housing module is built to match the original specifications for Barco iQ400 Series projectors that use a single lamp. It supplies a new, original-specification light source so the projector returns to its intended brightness and colour performance. The unit arrives as a complete housing, ready for installation without additional parts. It is aimed at owners and technicians who need a like-for-like replacement to restore image quality.

Single-lamp architecture limits total output

The projector uses a single-lamp design, so all light comes from this one module; there is no redundant lamp to maintain brightness if output declines. Brightness will gradually decrease as the lamp ages, and colour uniformity can shift over long run times. The projector’s built-in timer tracks usage, but the lamp itself provides no independent health reporting. Users must plan replacement based on hours logged or visible dimming, as the system cannot compensate for a fading source.

Replaces a dimmed or failed original lamp

This module replaces the factory lamp when its output has dropped below usable levels or when the projector indicates end-of-life. The jump is worth it when measured brightness no longer meets the installation’s requirements or when colour stability has drifted. It is not for users seeking higher lumen output than the original design, nor for multi-lamp projector models that require paired modules.