Jaspertronics EB-2255U-LAMP projector lamp housing

Direct replacement for EB-2255U

This Jaspertronics lamp-and-housing module is built as a direct replacement for the Epson EB-2255U projector. It arrives new with the original Ushio NSHA lamp already fitted inside the housing, so no separate bulb handling is required. Installation restores the projector to its factory brightness and colour balance without additional alignment steps. The unit is intended for education, business and home-cinema users who need a drop-in refresh.

Swaps out a dimmed or failed module

When the existing lamp reaches end of life or suffers a premature failure, this assembly replaces the complete optical engine rather than just the bare bulb. The swap is worthwhile once image brightness drops below usable levels or the projector signals a lamp-hour warning. Because the housing and lamp come pre-assembled, the changeover takes minutes and eliminates the risk of contaminating the optics during a bare-bulb exchange. Users who only need a spare for future maintenance can store the sealed unit until required.

Maintains output over the rated lifespan

The genuine Ushio NSHA lamp is engineered to hold consistent lumen output and colour fidelity across its full rated service interval. Thermal design inside the original housing manages heat so that brightness decay follows the manufacturer curve instead of accelerating early. Under continuous daily use the module delivers stable performance for presentations, lessons or film playback without the flicker or colour shift seen with aftermarket alternatives. The one-year warranty covers the complete assembly against early degradation.