Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00937447BTC
In stock
JacobsParts Inc.
JacobsParts Inc. LSA-O-10PK 10-pack 10mm 4-wire solderless track lighting connectors
Ten solderless 4-wire clips connect 10 mm RGB LED strips to controllers or extensions without soldering
- typeLED Light Strip Connector
- Solderless installation saves time with snap-shut design
- 15 cm pre-attached wires simplify controller connections
- 10 connectors per pack support multiple strip runs
- Fits 10 mm 4-conductor RGB strips for 5050 chips
- 4-pin colour-coded wiring prevents polarity mistakes
10-pack 10mm 4-wire solderless connectors
This pack supplies ten JacobsParts LSA-O-10PK connectors that join 10mm four-conductor RGB LED strips without soldering. Each clip opens at the top so the raw strip slides under the contact pins and locks shut, leaving a 15cm flying lead ready for a controller or another strip.
Installers who want quick RGB strip joints
The connectors suit anyone extending or terminating SMD 5050 colour-changing tape where a tool-free connection is preferred. They do not work with single-colour two-wire strips or any strip width other than 10mm, so projects needing those formats require different parts.
10mm four-conductor strip compatibility
Every clip is built exclusively for 10mm wide PCB strips carrying four conductors in an RGB layout. Using a strip with a different pin count or width will prevent the contacts from seating and the connection will fail.
Highlights
- Solderless installation saves time with snap-shut design
- 15 cm pre-attached wires simplify controller connections
- 10 connectors per pack support multiple strip runs
- Fits 10 mm 4-conductor RGB strips for 5050 chips
- 4-pin colour-coded wiring prevents polarity mistakes
Specifications
| Brand | JacobsParts |
|---|---|
| Model | LSA-O-10PK |
| type | LED Light Strip Connector |
Questions about this item
How many 10mm 4-wire connectors are included in the pack?
The pack contains 10 connectors, each with 15cm leads for linking SMD 5050 RGB strips to a controller or power supply.
Do the connectors generate noticeable heat when the strip runs continuously?
The connectors are passive wire-to-PCB clips; they add no active circuitry and therefore contribute no measurable heat during all-day operation.
What type of LED strip is required for these connectors to work?
They fit 10mm wide 4-conductor PCB strips built with SMD 5050 RGB chips, so you must already have that exact strip format.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
