Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00935186BTC
In stock
JacobsParts Inc.
JacobsParts Inc. LSA-J-10PK track lighting 10-pack 15cm 3528
Ten solderless flexible couplers join 8 mm single-colour 3528 LED strips with 15 cm wires for corner routing
- Country of OriginChina
- typeLED Light Strip Connector
- Solderless connection simplifies installation with no tools required
- 15 cm flexible wire bridges gaps around corners and contours
- 10-pack supplies enough couplers for multiple strip segments
- Designed for 8 mm 2-pin 3528 single-colour LED strips
- Secure clip-on design holds strips firmly without soldering
10-Pack Solderless LED Strip Couplers
This pack contains 10 flexible couplers designed to join two 8mm 2-conductor LED strips without soldering. Each coupler includes a 15cm wire lead that bridges gaps around corners or contours. The solderless clamp mechanism opens to accept the strip under the contact pins and closes to secure the connection. They are intended for single-colour strips using 3528 SMD chips.
Flexible 15cm Wire Bridges Gaps
The 15cm wire between the connector heads lets you route strips around tight bends or across small breaks in a cove or cabinet run. Because the connection is solderless, you can cut strips to length and reconnect them on site without a soldering iron. The 2-pin layout matches standard single-colour 8mm PCB strips, so polarity alignment is straightforward during installation.
Suits Single-Colour 8mm Strip Projects
These couplers work for installers joining 8mm 2-wire strips in single-colour lighting runs. They do not support RGB or addressable strips that require additional conductors. Builders needing waterproof sealing, higher current capacity or connections for multi-colour strips should look at alternative connector types.
Highlights
- Solderless connection simplifies installation with no tools required
- 15 cm flexible wire bridges gaps around corners and contours
- 10-pack supplies enough couplers for multiple strip segments
- Designed for 8 mm 2-pin 3528 single-colour LED strips
- Secure clip-on design holds strips firmly without soldering
Specifications
| Brand | JacobsParts |
|---|---|
| Model | LSA-J-10PK |
| Country of Origin | China |
| type | LED Light Strip Connector |
Questions about this item
Will the 2-pin solderless connectors on these 10 couplers need replacement after repeated strip adjustments?
The connectors are a solderless clip design; repeated opening and closing can fatigue the metal contacts, so plan to replace a coupler if the grip loosens or the strip flickers.
What limit appears first when the 15 cm flexible wire runs continuously at full strip current?
The 2-pin 8 mm PCB interface and thin flexible wire set the current ceiling; sustained maximum load will heat the connector junction before the strip itself.
How much heat or noise do the 3528-type couplers produce during all-day operation?
The couplers are passive with no fan or electronics; they emit no audible noise and only warm slightly at the contact points under normal single-colour strip loads.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
