We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Ironclad

Ironclad KCHA5-02-S Cut-Resistant Gloves HPPE 10 inch Pair

SKU CH-3ECR-WCETX

Cut-resistant HPPE knit gloves rated ANSI/ISEA A6 and EN 388:2016 4X42FP with double-dipped nitrile coating

  • ANSI/ISEA Cut Level A6 resists severe laceration risks
  • EN 388:2016 4X42FP rating confirms abrasion and tear durability
  • Double-dipped nitrile coating covers full hand for grip and chemical splash resistance
  • ANSI/ISEA 138 impact rating at 6.5 N protects knuckles from crushing blows
  • 10 inch length and ambidextrous fit shield wrist and both hands equally

Cut-Resistant HPPE Gloves for General Use

These gloves are built for workers who need reliable hand protection during general-purpose tasks. The HPPE knit shell delivers ANSI/ISEA Cut Level A6 resistance while the double-dipped nitrile coating covers the full hand. They are sold as a left-and-right pair in a 10 inch length. The bright orange colour aids visibility on busy job sites.

Sustained Abrasion and Impact Performance

The EN 388:2016 rating of 4X42FP shows the gloves maintain their protective qualities through extended wear rather than just a single test. An impact force rating of 6.5 N under ANSI/ISEA 138 confirms the back-of-hand guards absorb repeated knocks. Double-dipped construction prevents the coating from wearing through quickly during long shifts.

Deciding Factor: Cut Level A6 and Impact Rating

The combination of ANSI/ISEA Cut Level A6 with a certified impact force of 6.5 N determines if this pair matches your hazard assessment. Buyers who need a higher abrasion score or an insulated liner for cold environments should look elsewhere. The gloves meet EN 388:2016 and ANSI/ISEA 138 standards for the hazards listed.

Highlights

  • ANSI/ISEA Cut Level A6 resists severe laceration risks
  • EN 388:2016 4X42FP rating confirms abrasion and tear durability
  • Double-dipped nitrile coating covers full hand for grip and chemical splash resistance
  • ANSI/ISEA 138 impact rating at 6.5 N protects knuckles from crushing blows
  • 10 inch length and ambidextrous fit shield wrist and both hands equally

Specifications

BrandIRONCLAD

Questions about this item

Do the Ironclad KCHA5-02-S gloves stay cool and comfortable during a full shift of continuous wear?

The HPPE knit construction is breathable and the gloves are not insulated, so they avoid trapping heat during all-day use.

What hand measurements do I need to match before ordering the size S pair?

Size S fits a hand circumference of approximately 10 inches; measure around the knuckles of your dominant hand to confirm.

Can I wear these A6 cut-level gloves over the thinner liner gloves I already use for cold storage work?

The 10-inch length and knit wrist allow layering over light liners without restricting movement or compromising the EN 388 4X42FP impact rating.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.