We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Intermec large edge guide kit for PM23C PM43 PM43C printers

Intermec

Intermec 203-973-001 edge guide kit large pos accessory

SKU CH-7P4V-8JM1Z MPN 203-973-001

Large edge-guide kit aligns media on PM23C, PM43 and PM43C printers

  • Ensures accurate media alignment on large rolls
  • Compatible with PM23C, PM43 and PM43C printers
  • Genuine Honeywell accessory for reliable operation
  • Simple kit installation reduces downtime

Compatible printer models

This edge guide kit fits PM23C, PM43 and PM43C direct thermal and thermal transfer printers. It is sold new as an original Intermec accessory for point-of-sale environments. The kit provides a large media arm edge guide to support wider label rolls during printing. Installers can add it without modifying the printer chassis.

Thermals noise and power draw

The accessory has no moving parts, fans or power connections, so it adds no heat, noise or electrical load to the printer. Normal operation stays within the printer’s existing thermal and acoustic envelope. No additional power supply capacity is required.

Highlights

  • Ensures accurate media alignment on large rolls
  • Compatible with PM23C, PM43 and PM43C printers
  • Genuine Honeywell accessory for reliable operation
  • Simple kit installation reduces downtime

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the edge guide kit on my PM43 printer without misaligning the media arm?

Attach the large edge guide to the media arm using the supplied hardware, then adjust the guide so it just touches the label edge without pinching the stock; over-tightening is the common error that causes skewed prints.

When should I replace the edge guide on my PM23C if the plastic starts to wear?

Replace the guide once the contact surface shows visible grooves or the labels begin to drift sideways, typically after heavy roll throughput; the kit is a single-piece assembly so the whole unit is swapped at once.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.