INSEETECH
INSEETECH INS102-Cable 12-24V 5V 3A 49FT car electronics accessory
A 49 ft hardwire kit powers an INSEETECH 3-channel mirror dash cam from a 12-24 V vehicle supply with 5 V 3 A output and low-voltage protection
- TypeDash Installation Kits
- FeaturesDash Cam Hardwire Kit
- Height0.78 inches
- Width9.05 inches
- Length7.48 inches
- Weight4.76 Ounces
- 49 ft cable reaches every corner of large vehicles
- 12-24 V input protects battery with low-voltage cut-off
- 5 V 3 A output powers 3-channel mirror dash cam
- Red wire enables automatic reversing guide lines
- Polypropylene jacket withstands automotive temperature extremes
INSEETECH 3-Channel Mirror Dash Cam Hardwire Kit
This hardwire kit is built specifically for the INSEETECH 3-channel mirror dash cam and provides a 49FT cable to reach from the front unit to a rear camera on larger vehicles. It converts a 12-24V vehicle supply to the 5V 3A output the dash cam requires and includes low-voltage protection to prevent battery drain during 24-hour parking mode. The kit suits cars, trucks, trailers, vans and RVs.
Installation Wiring and Reversing Assistant
Three labelled wires connect to constant battery, ignition-switched ACC and a chassis ground point, while a dedicated red wire on the rear-camera lead activates an on-screen reversing guide when tied to the reversing-light positive. If the reversing assistant is not wanted the red wire can be left disconnected without affecting power delivery. Installation follows the dash cam user manual and requires no specialised tools.
Cable Length Limits and Vehicle Coverage
At 49FT the cable comfortably spans the full length of most cars, vans and RVs, allowing the rear camera to be mounted at the back of a long wheelbase or trailer. Runs significantly longer than 49FT are not supported by this kit, so builders needing extra reach for articulated lorries or extended conversions will need a different solution.
Highlights
- 49 ft cable reaches every corner of large vehicles
- 12-24 V input protects battery with low-voltage cut-off
- 5 V 3 A output powers 3-channel mirror dash cam
- Red wire enables automatic reversing guide lines
- Polypropylene jacket withstands automotive temperature extremes
Specifications
| Brand | INSEETECH |
|---|---|
| Model | INS102-Cable |
| Type | Dash Installation Kits |
| Features | Dash Cam Hardwire Kit |
| Height | 0.78 inches |
| Width | 9.05 inches |
| Length | 7.48 inches |
| Weight | 4.76 Ounces |
| Cable | Dash Cam Hardwire Kit |
| Color | Black |
| Compatibility | only for INSEETECH 3-Channel Mirror Dash Cam |
| Material | Polypropylene (PP) |
| Size/Dimensions | 7.48*9.05*0.78 inches |
Questions about this item
Is the 49 ft cable the only length offered for the INS102-Cable?
Yes, the hardwire kit comes in a single 49 ft length designed for the 3-channel mirror dash cam.
What does the 5 V 3 A output mean when the kit is wired into a vehicle?
It converts the 12-24 V vehicle supply to a steady 5 V at up to 3 A, powering the dash cam and enabling 24-hour parking monitoring without draining the battery.
Which connector standard does the kit use and what does it limit?
The kit uses a 4-pin Mini USB connector that carries the converted 5 V 3 A output; it cannot supply higher voltages or currents.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
PAC APH-TY02 Speaker Connection Harness Toyota Lexus 18
- Car Stereo Add-Ons
The Wires Zone Platinum 1/0 AWG Ring Terminals Pair
- Connector and Termi…



