Innocard
Innocard EP8102 PCIe Gen5 gender changer MCIO 38P dual port to U.3 100cm cablex2pcs
Converts dual MCIO 38P ports to PCIe Gen5 x8 with a built-in ReDriver and clock buffer for extended signal reach over 100cm cables
- Changer TypePCIe Gen5
- Converts dual MCIO 38P ports to PCIe x8 Gen5
- Built-in ReDriver extends PCIe 5.0 8-lane signal reach over 100cm cables
- Integrated clock buffer and SMBus switch maintain signal integrity
- On-board LED indicators show PRSNT#, power rails and side-band status
- Designed and made in Taiwan by Innocard
PCIe Gen5 MCIO 38P Adapter
The Innocard EP8102 converts a PCIe x8 Gen5 link into two MCIO 38P ports using a built-in ReDriver and clock buffer. It targets system integrators extending high-speed storage or accelerator connections beyond standard board-edge reach. The adapter includes SMBus switch and I/O expander logic for out-of-band management of remote port resets.
Sustained Signal Integrity
Integrated ReDriver and 100MHz clock buffer compensate for insertion loss across longer traces and the supplied 100cm cables. PERST#, WAKE# and CLKREQ# buffer gates maintain link stability under continuous 5.0 GT/s per lane operation. Green status LEDs show PRSNT#, auxiliary and main rail readiness plus inverted PERST# and WAKE# states for quick diagnostics.
Replaces Direct Board Routing
This gender changer replaces fixed motherboard MCIO headers when chassis depth or backplane layout demands remote drive placement. The jump is worth it when cable runs exceed on-board trace budgets or when hot-plug management via SMBus addresses 0x6C, 0x70 and 0x20 is required. Buyers needing single-port or internal-only cabling should look elsewhere.
Highlights
- Converts dual MCIO 38P ports to PCIe x8 Gen5
- Built-in ReDriver extends PCIe 5.0 8-lane signal reach over 100cm cables
- Integrated clock buffer and SMBus switch maintain signal integrity
- On-board LED indicators show PRSNT#, power rails and side-band status
- Designed and made in Taiwan by Innocard
Specifications
| Changer Type | PCIe Gen5 |
|---|
Questions about this item
Does the EP8102 add audible noise or extra heat when running a PCIe 5.0 x8 link continuously?
The board is a passive gender changer with a ReDriver and clock buffer; it has no fan or active cooling, so it adds no audible noise and minimal heat under continuous load.
What host connector and slot width must my motherboard provide for the EP8102 to operate?
The adapter requires a PCIe x8 slot wired for Gen 5 signalling to convert the link to dual MCIO 38P ports.
Can I keep my existing PCIe 4.0 or 3.0 storage devices when using this Gen 5 gender changer?
Yes, the ReDriver extends the 5.0 8-lane signal so the link will train down to 4.0 or 3.0 speeds with older endpoints.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00114926BTC
In stock
