Ingersoll/Rand
Ingersoll/Rand ML500K-2C10-C6 Air Chain Hoist 1100 lb 10 ft
Air-powered chain hoist lifts 1,100 lb to 10 ft at 55 fpm with pendant control and 18 in headroom
- 1100 lb lifting capacity for heavy industrial loads
- 10 ft lift height reaches elevated work areas
- 55 fpm fixed speed provides consistent operation
- 18 in headroom fits tight overhead spaces
- 70 cfm at 90 psi runs on standard shop air
1100 lb Air Chain Hoist
The Ingersoll/Rand ML500K-2C10-C6 is a hook-mounted air chain hoist rated for a maximum lifting capacity of 1100 lb. It provides a fixed lift speed of 55 fpm with a maximum lifting length of 10 ft. The unit requires a compressed air supply at up to 90 psi and consumes a maximum of 70 cfm during operation.
Sustained Duty Performance
With a fixed lift speed of 55 fpm the hoist maintains consistent travel under continuous load without the acceleration limits of variable-speed drives. Maximum air consumption of 70 cfm at 90 psi means the compressor must sustain that flow rate for the duration of the lift cycle. The non-programmable pendant gives direct manual control for repetitive positioning tasks.
Thermals Noise and Power
Air-driven operation eliminates motor heat build-up during extended lifts, so duty cycle is limited by compressor capacity rather than internal temperature rise. Exhaust air discharges at the muffler, producing typical pneumatic noise levels that vary with supply pressure and piping. Power draw is determined entirely by the compressor delivering 70 cfm at 90 psi.
Highlights
- 1100 lb lifting capacity for heavy industrial loads
- 10 ft lift height reaches elevated work areas
- 55 fpm fixed speed provides consistent operation
- 18 in headroom fits tight overhead spaces
- 70 cfm at 90 psi runs on standard shop air
Specifications
| Brand | INGERSOLL-RAND |
|---|
Questions about this item
How much compressed air will the ML500K-2C10-C6 consume when running continuously at 90 psi?
The hoist draws a maximum of 70 cfm at 90 psi, so plan your compressor capacity and piping to sustain that flow during extended lifts.
What size air supply line and fitting does the 1/2 in NPT female inlet require?
Connect a 1/2 in NPT male fitting to the hoist inlet; use hose or piping rated for at least 90 psi to avoid pressure drop at 70 cfm.
Will the 18 in headroom and hook mount clear the same overhead structure as my old electric hoist?
The hook-mounted body needs 18 in of vertical clearance and has no trolley, so verify your beam flange can accept a fixed hook and that 18 in fits below it.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
