Ingersoll/Rand
Ingersoll/Rand 93LA1 air digger striking tool 2350 BPM 45.0 CFM
Air digger delivers 2350 blows per minute at 45.0 CFM with latch retainer for light and medium work
- Delivers 2350 blows per minute for fast material removal
- 0 CFM airflow sustains high‑power operation
- 90 psi required pressure matches standard shop compressors
- Latch retainer allows quick tool changes on site
- D‑grip handle improves control during extended use
Air Digger for Light and Medium Work
The Ingersoll/Rand 93LA1 is a pneumatic striking tool built for demolition and excavation tasks. It uses a latch retainer that suits light- and medium-weight applications where controlled impact is required. The D-grip handle gives the operator a secure hold during extended use. This tool connects to a compressed air supply through a standard 3/8 In. NPT inlet.
2350 BPM Impact Rate with 45.0 CFM Demand
At full load the tool delivers 2350 blows per minute while consuming 45.0 CFM at 90 psi. A minimum 1/2 In. hose is needed to maintain that airflow without starving the piston. The 2-1/2 In. stroke and 1-11/16 In. bore determine the force per blow. Insufficient compressor capacity or an undersized hose will reduce the blow rate and stall the tool under load.
7/8 x 3-1/4 In. Shank Fits Latch Retainer
The 7/8 x 3-1/4 In. shank dimension is the single specification that decides compatibility with your existing chisels and accessories. Only steels machined to that exact shank will lock into the latch retainer correctly. Verify the shank size before purchase; mismatched tooling cannot be used safely or effectively with this air digger.
Highlights
- Delivers 2350 blows per minute for fast material removal
- 0 CFM airflow sustains high‑power operation
- 90 psi required pressure matches standard shop compressors
- Latch retainer allows quick tool changes on site
- D‑grip handle improves control during extended use
Specifications
| Brand | Ingersoll-Rand |
|---|---|
| Model | 93LA1 |
Questions about this item
Will the 3/8 In. NPT air inlet on the 93LA1 connect directly to my existing 1/2 In. hose?
The tool has a 3/8 In. NPT inlet; the manufacturer specifies a minimum hose size of 1/2 In., so an adapter or fitting is needed to join the two.
How can I confirm the 93LA1 is delivering its rated 2350 BPM at 90 psi after installation?
Verify supply pressure reads 90 psi at the inlet while the tool runs; the 45.0 CFM full-load rating means your compressor must sustain that flow to maintain rated blows per minute.
Does the 93LA1 ship with any chisels or only the latch-retainer body?
The supplied data lists the digger body with D-grip handle and latch retainer; chisels or bits for the 7/8 x 3-1/4 In. shank are not included and must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
