INEO
INEO 20G USB 3.2 Gen 2x2 Type-C NVMe M-Key Enclosure with Fan
Houses an M-key NVMe SSD with a built-in 6000 RPM PWM fan and silicone thermal pad for active cooling during 20 Gbps USB 3.2 Gen 2x2 transfers
- Active cooling with a 3.3V 6000 RPM PWM silent fan
- Silicone thermal pad included for sustained high-speed transfer
- 20Gbps USB 3.2 Gen 2x2 Type-C interface
- M-key NVMe PCIe SSD only — no SATA or NGFF support
- Fan must sit near USB port or it will not activate
20 Gbps NVMe M-Key Enclosure
This INEO enclosure connects an M-Key NVMe PCIe SSD via a USB 3.2 Gen 2x2 Type-C interface rated at 20 Gbps. A built-in PWM fan spinning at 6000 RPM and a bundled silicone thermal pad provide active cooling during sustained transfers. The unit is designed exclusively for NVMe drives and does not accept SATA or NGFF M.2 modules.
Suits owners of M-Key NVMe SSDs needing fast
Builders who need to use SATA M.2 or NGFF drives cannot use this enclosure. Users whose hosts only offer slower USB generations will not reach the 20 Gbps ceiling. The fan must be positioned near the USB port after assembly or it will not activate.
USB 3.2 Gen 2x2 20 Gbps Type-C interface
The enclosure's single decisive specification is its 20 Gbps USB 3.2 Gen 2x2 Type-C connection, which sets the maximum throughput for the installed NVMe SSD. Hosts equipped with USB 4.0 at 40 Gbps can exceed this limit, while slower ports will constrain performance accordingly.
Highlights
- Active cooling with a 3.3V 6000 RPM PWM silent fan
- Silicone thermal pad included for sustained high-speed transfer
- 20Gbps USB 3.2 Gen 2x2 Type-C interface
- M-key NVMe PCIe SSD only — no SATA or NGFF support
- Fan must sit near USB port or it will not activate
Specifications
No published specifications for this item yet.
Questions about this item
Which M.2 SSD lengths and keying does the INEO 20G enclosure accept?
It accepts M.2 NVMe PCIe M-Key drives only; NGFF or SATA M.2 SSDs are not supported.
How do I install the SSD so the built-in PWM fan actually spins?
Slide the NVMe M-Key SSD into the slot, apply the bundled silicone thermal pad, then close the case with the fan positioned next to the USB-C port — if the fan ends up on the opposite side it will not activate.
When should I replace the bundled silicone thermal pad?
Replace the pad if it becomes brittle, loses tackiness or no longer makes full contact with the SSD controller after repeated drive swaps.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
