We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Neon green plastic case for a 3.5 SATA drive

iMBAPrice

iMBAPrice Zipo 3.5" Hard Drive Protector Case Neon Green

SKU CH-T3KS-MHD90

A stackable 3.5" SATA/IDE hard-drive case that is water, dust, static and collision proof with a built-in label area

  • Water, dust and quake proof protection for 3.5" SATA drives
  • Anti-static and anti-collision design safeguards sensitive data
  • Stackable case enables organised storage of multiple drives
  • Built-in label area allows quick identification of contents
  • Supports both 3.5" SATA and IDE hard drives

Stackable 3.5" HDD protector case

The iMBAPrice Zipo case is a water proof, static proof, and collision proof enclosure built for a single 3.5" SATA or IDE hard drive. A built-in label lets you write directly on the housing for quick identification. The case is designed to stack with other Zipo 3.5 inch protectors.

Replaces loose anti-static bags

When drives are handled often or stored long term, the sealed shell guards against dust, moisture, and impact better than a bag alone. The jump is worth it if you move drives between locations or keep spares in a busy workshop.

Check drive height and connector orientation

The case fits standard 3.5" SATA and IDE drives, but thicker enterprise models or drives with oversized side-mounted connectors may not seat properly. Verify the drive slides in fully and the lid closes without forcing.

Highlights

  • Water, dust and quake proof protection for 3.5" SATA drives
  • Anti-static and anti-collision design safeguards sensitive data
  • Stackable case enables organised storage of multiple drives
  • Built-in label area allows quick identification of contents
  • Supports both 3.5" SATA and IDE hard drives

Specifications

BrandiMBAPrice

Questions about this item

What size hard drive does the 3.5" Zipo case accept?

The case is built for 3.5-inch SATA or IDE hard drives and will not fit 2.5-inch or M.2 drives.

How do I install a drive in the stackable protector case?

Open the latch, slide the 3.5" drive in until it seats firmly, then close the latch; the common mistake is leaving the latch unlatched so the drive can shift.

Will the anti-static and waterproof protection degrade over time?

The anti-static lining and waterproof seal are moulded into the case body and do not wear out, so no periodic replacement is needed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.