We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Hand-held cable tester with RJ45 RJ11 RJ12 ports detachable remote unit black plastic case

iMBAPrice

iMBAPrice RJ45/RJ11/RJ12 Cable Tester Accessory

SKU CH-DMFS-DVKXT

Tests RJ45, RJ11 and RJ12 cables for pass, open, short or cross-wire faults with scan or step modes and a detachable remote unit

  • Tests RJ45, RJ11 and RJ12 cables for continuity
  • Identifies open, short and cross-wire faults
  • Scan and step modes for quick or pin-by-pin checks
  • Detachable remote unit tests installed wiring runs
  • Powered by a 9 V battery (not included)

Network Cable Tester for LAN and Phone Lines

This tester checks RJ45 network patch cables and RJ11 telephone cables for continuity faults. It identifies pass, open, short or cross-wire conditions. The tool suits installers and IT staff verifying wiring in home or office environments. A detachable remote unit enables testing of cables already terminated at both ends.

Scan and Step Test Modes

Users can select scan mode for rapid end-to-end verification or step mode to inspect each contact individually. The remote module separates from the main unit so installed runs can be tested without removing cables. A 9-volt battery powers the device and is not included in the package.

Tests CAT5 through CAT7 UTP Wiring

The unit validates unshielded twisted-pair cables rated up to CAT7, covering typical LAN and phone installations. It does not certify bandwidth or measure signal quality, only wiring continuity. Buyers needing cable certification, fibre testing or PoE load analysis will require different equipment.

Highlights

  • Tests RJ45, RJ11 and RJ12 cables for continuity
  • Identifies open, short and cross-wire faults
  • Scan and step modes for quick or pin-by-pin checks
  • Detachable remote unit tests installed wiring runs
  • Powered by a 9 V battery (not included)

Specifications

BrandiMBAPrice

Questions about this item

What does the scan mode actually show when I test a cable?

Scan mode runs through every contact automatically and reports whether the link passes, has an open circuit, a short circuit or crossed wires.

Which connector types does the tester accept on its ports?

The unit has ports for RJ45, RJ11 and RJ12 plugs so you can check LAN patch leads and telephone cords.

How is the remote unit attached and what does it let me do?

The remote unit detaches from the main tester, allowing you to verify cables that are already installed in walls or ceilings.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.