Hubbell Incorporated
Hubbell Incorporated WS2000NW Occupancy Sensor PIR 1200 sq ft White
Wall-switch motion sensor covers 1,200 sq ft with passive infrared detection and adjustable 20-second to 30-minute time delay
- Covers large areas with 1200 sq ft PIR detection
- Adjustable timing from 20 sec to 30 min suits any room
- Works on 120V or 277V AC circuits for flexible wiring
- Integrated nightlight adds low-level illumination after dark
- White finish blends cleanly with standard wall switch plates
Sensor type and coverage
The Hubbell WS2000NW is a passive infrared occupancy sensor with an integrated nightlight, designed for indoor wall-switch-box mounting. It detects motion across 1200 square feet at the suggested mounting height, making it suitable for offices, conference rooms and similar spaces where automatic lighting control is required.
Sustained operation behaviour
The unit operates on hard-wired 120V AC or 277V AC supplies and holds lights on for a programmable delay between 20 seconds and 30 minutes after the last detected movement. This range lets installers match the timeout to typical occupancy patterns without the sensor cycling too frequently during continuous use.
Installation notes and common issues
Wiring is a standard hard-wired connection into a single-gang wall box, and the white finish matches common decorator devices. The most frequent issue is reduced coverage when the sensor is mounted higher than the suggested height or when partitions block the infrared field, so verify sight lines before finalising the location.
Highlights
- Covers large areas with 1200 sq ft PIR detection
- Adjustable timing from 20 sec to 30 min suits any room
- Works on 120V or 277V AC circuits for flexible wiring
- Integrated nightlight adds low-level illumination after dark
- White finish blends cleanly with standard wall switch plates
Specifications
| Brand | HUBBELL WIRING DEVICE-KELLEMS |
|---|
Questions about this item
How much power does the WS2000NW draw when it is running continuously?
The sensor operates on 120V AC or 277V AC hard-wired supply; its own standby draw is minimal and not separately rated.
What existing wiring must be in place for the WS2000NW to function?
A standard wall-switch box with 120V AC or 277V AC circuit wiring is required for hard-wired installation.
Will the WS2000NW control older fluorescent ballasts or LED drivers without flicker?
Yes, the passive infrared sensor switches the connected 120V AC or 277V AC load — ballasts or drivers — with a 20 sec to 30 min adjustable time delay.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
