Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00922039BTC
In stock
Hubbell Incorporated
Hubbell Incorporated MR11LRSP Lighted Rocker Switch
Marine-grade SPST rocker switch with red LED indicator, 0.250 in quick-connect tabs and 5 A at 12 V DC rating for bilge and accessory circuits
- TypeLight Switch
- Color MappingBlack
- Red indicator shows status at a glance
- SPST on/off control for simple circuit operation
- 5 A at 12 V DC rating for reliable low-voltage switching
- Quick-connect tabs speed up installation time
- Fits standard 0.875 in x 1.500 in mounting cut-out
Marine SPST Rocker Switch
The Hubbell Wiring Device-Kellems MR11LRSP is a single-pole single-throw lighted rocker switch designed for 12 V DC marine circuits. It carries a 5 A rating and uses a red indicator lamp to show the on position. Four 0.250 in quick-connect tabs provide the electrical connections. The body and actuator are black.
Suits 12 V accessory panels; not for AC mains
Builders wiring bilge blowers, bilge pumps or accessory lights on 12 V systems will find the 5 A DC rating and 0.875 in x 1.500 in mounting hole a direct fit. Installers working on AC shore-power circuits or loads above 5 A should select a differently rated device. The operating range of 32 Degrees to 100 Degrees F covers typical marine environments.
5 A at 12 V DC contact rating
This single figure determines whether the switch can handle the intended load. The four quick-connect terminals and SPST on/off function support simple accessory circuits within that limit. Exceeding 5 A on a 12 V DC circuit requires a heavier-duty switch.
Highlights
- Red indicator shows status at a glance
- SPST on/off control for simple circuit operation
- 5 A at 12 V DC rating for reliable low-voltage switching
- Quick-connect tabs speed up installation time
- Fits standard 0.875 in x 1.500 in mounting cut-out
Specifications
| Type | Light Switch |
|---|---|
| Brand | Hubbell Wiring Device-Kellems |
| Color Mapping | Black |
Questions about this item
What does the 5 A at 12 V DC rating mean for a bilge pump or blower?
The switch can safely control a 12 V DC load up to 5 amps, so it suits typical bilge pumps, blowers or lights within that current draw.
How do the 0.250 in quick-connect tabs affect wiring?
They accept standard 0.250 in female spade terminals, letting you crimp or push on wires without soldering.
Will the 0.875 in by 1.500 in mounting hole fit my dash panel?
Cut a rectangular opening of those dimensions; the switch body is designed to snap into that exact cut-out.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
