Hubbell Incorporated
Hubbell Incorporated IEC Pin and Sleeve Receptacle 100A 250V Orange
Watertight IEC pin-and-sleeve receptacle rated 100 A at 250 V AC with IP67 and NEMA 4X protection, 10 hp motor rating, spring-loaded cap.
- Color/FinishOrange
- Color MappingOrange
- TypeLight Switch
- Watertight IP67 rating protects against dust and immersion
- 100 A current rating supports heavy industrial loads
- 250 V AC three-phase power suits demanding equipment
- Spring-loaded cap seals the connection when not in use
- Thermoplastic orange housing resists impact and corrosion
Industrial 100 A Receptacle
This IEC pin-and-sleeve receptacle delivers 100 A at 250 V AC for three-phase industrial equipment. The orange thermoplastic housing meets IP67 and NEMA 4X ratings for watertight performance in harsh environments. A spring-loaded cap protects the contacts when the receptacle is not mated. The straight flange mount accepts wire up to 1/0 AWG for secure power connections.
Suited for High-Current Three-Phase Loads
Installations that require 100 A three-phase service with grounded IEC pin-and-sleeve geometry will use this receptacle. Builders needing a lower current rating, a different voltage class, or a non-IEC grounding style should select another device. The single-gang flange and straight orientation suit panel or enclosure mounting where space permits the 4.71 in face diameter.
100 A Current Rating Determines Fit
The 100 A rating is the primary specification that decides whether this receptacle matches the circuit and inlet. Verify that the supply breaker, cable ampacity, and mating plug are all rated for 100 A at 250 V AC three-phase before specifying this part.
Highlights
- Watertight IP67 rating protects against dust and immersion
- 100 A current rating supports heavy industrial loads
- 250 V AC three-phase power suits demanding equipment
- Spring-loaded cap seals the connection when not in use
- Thermoplastic orange housing resists impact and corrosion
Specifications
| Brand | HUBBELL |
|---|---|
| Color/Finish | Orange |
| Color Mapping | Orange |
| Type | Light Switch |
Questions about this item
What flange diameter and enclosure rating does this 100 A receptacle need for mounting?
The face diameter is 4.71 in and the enclosure carries a NEMA 4X rating for a watertight fit.
How do you wire the 1/0 AWG conductors into the spring-loaded cap, and what step is often missed?
Strip each of the four wires to the terminal depth, insert fully into the straight-oriented sleeves, then snap the spring-loaded cap shut — skipping the cap latch leaves the IP67 seal open.
When should the orange thermoplastic housing or cap be replaced in an industrial three-phase circuit?
Replace the housing or spring-loaded cap if cracks appear, the orange colour fades from UV exposure, or the IP67 seal no longer holds after repeated 10 hp motor starts.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



