We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Gray metallic raceway tee fitting for 4000 series

Hubbell Incorporated

Hubbell Incorporated HBL4715GY Raceway Tee Fitting Gray

SKU CH-8MPH-WCRGY

A gray metallic tee fitting measuring 10.93 inches long and 1.62 inches wide for branching Hubbell 4000 series raceway

  • weight3.16
  • Creates secure three-way junctions for 4000 series raceway
  • Metallic construction resists impact in commercial environments
  • Compact 1.62 in width fits tight wall spaces
  • Lightweight 3.16 lb design simplifies overhead mounting

Hubbell HBL4715GY raceway tee fitting

The Hubbell HBL4715GY is a metallic raceway tee fitting finished in gray. It connects three sections of Hubbell 4000 series raceway to route cables around corners or junctions. The component measures 10.93 inches long, 7.27 inches high and 1.62 inches wide. It is intended for installers extending surface-mounted cable management systems.

New condition, 3.16 weight, passive operation

Supplied new, the fitting weighs 3.16 units and contains no moving parts, fans or electronics. It draws no power and produces no noise during normal use. Thermals are not a consideration because the fitting does not carry current or generate heat. The passive design suits indoor installations where silent cable routing is required.

Highlights

  • Creates secure three-way junctions for 4000 series raceway
  • Metallic construction resists impact in commercial environments
  • Compact 1.62 in width fits tight wall spaces
  • Lightweight 3.16 lb design simplifies overhead mounting

Specifications

weight3.16

Questions about this item

How is the HBL4715GY tee fitting installed into a 4000 series raceway, and what step is often missed?

Mount the fitting to the raceway base using the supplied hardware, then snap the cover on; the step often missed is tightening the cover screws to maintain the 7.27-inch height alignment.

What maintenance or replacement will the gray metallic tee fitting need over time?

Inspect the gray finish for corrosion and verify the 1.62-inch width stays secure; replace the fitting if the metallic body shows damage that could affect the 10.93-inch length continuity.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.