Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00919927BTC
In stock
Hubbell Incorporated
Hubbell Incorporated FT3BR5 Cable Protector 5 ft
A brown PVC cable protector with a single channel holds cables up to 1/2 in diameter and meets ADA requirements
- TypeCable Management & Conduit
- Protects cables with a single 1/2 in high channel
- Supports cables up to 1/2 in diameter
- Meets ADA accessibility requirements
- Smooth PVC surface resists snagging
- Five-foot length covers extended runs
Hubbell FT3BR5 cable protector
The Hubbell FT3BR5 is a single-channel cable protector made from brown PVC. It runs five feet long and measures three inches wide with a three-quarter-inch profile. The channel accepts cables up to one-half inch in diameter and meets ADA compliance with a smooth surface texture.
Suited for temporary indoor or outdoor cord coverage
Installers protecting a single power or data lead across walkways, doorways or event flooring will find the low-profile design unobtrusive and compliant. Buyers who need multiple channels, higher load ratings or heavier-duty materials should look at something else.
Performs steadily under continuous foot traffic
The PVC body resists cracking and deformation when subjected to sustained pedestrian loads over long periods. Its smooth texture maintains grip without abrasion, and the ADA-compliant height stays consistent throughout extended use.
Highlights
- Protects cables with a single 1/2 in high channel
- Supports cables up to 1/2 in diameter
- Meets ADA accessibility requirements
- Smooth PVC surface resists snagging
- Five-foot length covers extended runs
Specifications
| Brand | HUBBELL WIRING DEVICE-KELLEMS |
|---|---|
| Type | Cable Management & Conduit |
Questions about this item
Does this cable protector need any extra connectors or mounting hardware to stay in place?
The protector is a single 5 ft length of brown PVC with one channel and a smooth texture; it lays flat and relies on its own weight and the channel walls to hold cables, so no separate connectors or mounting brackets are required.
Can I run this alongside older cable covers that are only 1/2 in high?
This unit stands 3/4 in high with a 1/2 in channel height, so it sits slightly taller than 1/2 in covers; cables up to 1/2 in diameter fit inside, and the smooth brown PVC surface will butt against lower-profile covers without damaging them.
How can I confirm the protector is ADA compliant once it is installed?
The product is marked ADA compliant; after laying the 5 ft section flat, verify the top surface is flush with the surrounding floor and the 3/4 in height does not create a trip edge — if the transition is level, the installation meets the compliance intent.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
