Hubbell Incorporated
Hubbell Incorporated DSM30W1 24V DC Wall Switch Push Button Momentary White
A 24 V DC momentary push-button wall switch with a single white button for low-voltage control circuits
- Low-voltage control with 24 V DC operation
- Momentary push-button gives precise manual switching
- Single-button layout keeps wall plate uncluttered
- White finish matches standard décor
- Hard-wired communication ensures reliable signal path
24 V DC Momentary Push-Button Switch
This low-voltage wall switch provides a single momentary push button for 24 V DC control circuits. It is intended for installers and maintenance teams who need a simple hard-wired input device in commercial or industrial settings. The white finish suits standard wall-plate aesthetics. No dimming or sensor functions are included.
30 V DC Rating and 120 V AC Not Applicable
The switch carries a 30 V DC rating, giving headroom above the 24 V DC operating voltage for typical control loads. It is not rated for 120 V AC line-voltage switching, so it cannot be used directly on mains lighting circuits. A neutral connection is required for the device to operate correctly.
Hard-Wired Communication
The unit communicates through hard-wired connections and uses passive infrared sensing technology for vacancy detection. Power draw in normal use is limited to the low-voltage control circuit, producing negligible heat and no audible noise. The absence of a nightlight or dimming circuitry keeps the thermal load minimal.
Highlights
- Low-voltage control with 24 V DC operation
- Momentary push-button gives precise manual switching
- Single-button layout keeps wall plate uncluttered
- White finish matches standard décor
- Hard-wired communication ensures reliable signal path
Specifications
| Brand | HUBBELL WIRING DEVICE-KELLEMS |
|---|
Questions about this item
Will the 24V DC momentary switch work with my existing 120V AC lighting circuit?
The switch operates at 24V DC and requires a neutral wire; it is not rated for direct 120V AC load switching so a compatible low-voltage controller or relay is needed.
How can I verify the push-button is functioning correctly after wiring it?
Press the white momentary button; the connected 24V DC load should activate only while the button is held and release immediately when you let go.
Does the DSM30W1 package include a mounting box or 24V power supply?
The box contains only the white wall switch; a suitable 24V DC power source, low-voltage wiring and an appropriate electrical box must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
