We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green PCIe card with two RJ45 ports and low-profile bracket

HPE

HPE NC360TProduct PCI-Express Dual Port Gigabit network card

SKU CH-50H2-9KV83 MPN NC360TProduct

Adds two Gigabit Ethernet ports via a PCI Express x4 slot, supporting Wake-on-LAN, PXE, Jumbo Frames, fault tolerance, load balancing and offload features

  • Speed10/100/1000Base-T
  • Connectors10/100/1000Base-T
  • InterfacePCI-Express
  • Dual RJ-45 ports give two Gigabit links
  • PCI Express x4 host interface fits standard and low-profile slots
  • Wake-on-LAN and PXE enable remote power-on and network boot
  • Jumbo Frames plus segmentation and Large Send Offload raise throughput
  • Network Fault Tolerance and Load Balancing keep traffic flowing

Dual-port Gigabit server adapter

The HPE NC360TProduct is a PCI-Express network card with two RJ-45 ports supporting 10/100/1000Base-T speeds. It is designed for servers that need an extra Gigabit Ethernet connection for general networking or failover. The low-profile form factor fits standard or compact chassis slots. Wake-on-LAN and PXE support simplify remote management and deployment.

Low power draw and silent operation

As a passive add-in card it draws minimal power from the PCI Express x4 slot and produces no acoustic noise. No active cooling is required so thermals stay within the host system airflow. Jumbo Frames and offload features such as Large Send Offload reduce CPU overhead during normal traffic. The 2.7 inch width leaves room for adjacent cards in dense configurations.

Sustained throughput with load balancing

Under continuous load the dual ports can share traffic through Network Fault Tolerance and Load Balancing modes. Segmentation offload and Large Send Offload keep processor utilisation steady during prolonged transfers. The adapter maintains line-rate Gigabit performance on both ports simultaneously without throttling. It is not suited for links faster than 1000 Mbps or for fibre media.

Highlights

  • Dual RJ-45 ports give two Gigabit links
  • PCI Express x4 host interface fits standard and low-profile slots
  • Wake-on-LAN and PXE enable remote power-on and network boot
  • Jumbo Frames plus segmentation and Large Send Offload raise throughput
  • Network Fault Tolerance and Load Balancing keep traffic flowing

Specifications

BrandHPE
Speed10/100/1000Base-T
Connectors10/100/1000Base-T
InterfacePCI-Express

Questions about this item

How do I install the NC360T in a PCI Express x4 slot and avoid the low-profile bracket mistake?

Insert the card into any PCI Express x4 slot, secure the full-height bracket, then swap to the included low-profile bracket only if the chassis requires it; the 2.7" width fits standard and low-profile slots.

Which replaceable part on the NC360T will need attention after extended operation?

The two RJ-45 port latch tabs can fatigue from repeated cable cycles; keep spare patch cables on hand so a worn tab does not interrupt the link.

What throughput ceiling appears first when both ports run sustained 1000Base-T traffic?

The PCI Express x4 host interface caps combined throughput at the bus limit, so sustained dual-port line-rate traffic will saturate the host bus before the 10/100/1000Base-T ports do.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.