We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
HPE Juniper Networking DPCE-R-4XGE-XFP 4-port switch module, rectangular metal unit, four network ports visible

HPE Juniper Networking

HPE Juniper Networking DPCE-R-4XGE-XFP 4 Port Switch Module

SKU CH-K0HT-R0K1W

Adds four 10/100/1000 WAN ports in a compact 5.9 × 4.1 × 2.5 in module

  • Four 10/100/1000 WAN ports for flexible copper connectivity
  • Compact 5.9 x 4.1 x 2.5 inch form factor fits dense racks
  • Zero PoE power draw simplifies power budgeting
  • New condition ensures full manufacturer specification compliance
  • Designed for reliable switching in space-constrained environments

Compact 4-port switch module

The HPE Juniper Networking DPCE-R-4XGE-XFP is a 4-port switch module built for wired networking installations. It provides four WAN ports that operate at 10, 100 or 1000 Mbps speeds. The thin profile suits environments where rack or enclosure space is limited. This module targets IT teams and home-office users who need reliable switching without PoE support.

Passive thermal design and zero PoE draw

With no Power over Ethernet capability the module draws no PoE budget and generates minimal heat. The compact dimensions of 5.9 x 4.1 x 2.5 inches allow airflow in dense chassis without requiring active cooling fans. Power consumption stays low because all four ports are standard copper Ethernet interfaces. Silent operation makes it suitable for quiet office or lab settings.

Fits standard Juniper chassis slots

The module slides directly into a compatible Juniper line-card slot, freeing external rack space for other equipment. No separate power supply or mounting hardware is needed beyond the host chassis. Four copper ports provide immediate uplinks for servers, access points or workstations. Builders who require PoE, fibre uplinks or higher port density must select a different module.

Highlights

  • Four 10/100/1000 WAN ports for flexible copper connectivity
  • Compact 5.9 x 4.1 x 2.5 inch form factor fits dense racks
  • Zero PoE power draw simplifies power budgeting
  • New condition ensures full manufacturer specification compliance
  • Designed for reliable switching in space-constrained environments

Specifications

ModelDPCE-R-4XGE-XFP

Questions about this item

How do I install the DPCE-R-4XGE-XFP module in a compatible Juniper chassis?

Power down the chassis, remove the blank panel from an available DPC slot, slide the module in until the ejector levers engage, then secure both captive screws. The step often missed is tightening both screws fully to ensure the backplane connectors seat correctly.

What maintenance or replacement will the DPCE-R-4XGE-XFP need over time?

The module has no PoE circuitry or flash memory, so there are no power-supply capacitors or storage media to replace. Maintenance is limited to keeping the chassis air filters clean and reseating the module if a port link fails after a thermal cycle.

What is the first limit reached when all four 10/100/1000 ports run sustained line-rate traffic?

The forwarding performance and switching capacity are both listed as zero, so the module’s internal fabric becomes the bottleneck before the 1000 Mbps per port ceiling is reached.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.